For some reason the choke does not always work when I push the key in the activate the it and I have to do it manually. Any ideas on what to do?
Thanks
I finally got angry at some local welder about welding my skeg so I told him where to go and that I would fix it myself. I bought the plastic skeggard that you see in overton's and marine tex. The only skeg I had left was about 2" by 2" right above the prop so there was not much left. I first...
I finally took out the stuck open thermostat out and put in a new one. I started the motor and let it run for at least 10 mins the thermostat did not open. The gauge read about 90F and I don't understand why the engine is not warming up. I only ran it on land with the water ears on. Is this ok...
I have had my 89 85hp force for some time and I am know that they smoke due to the gas/oil mixture and I was woundering if I can change the mixture to 40;1 to lower smoke and not do any damage.
I had my boat fixed for no spark and the guy completly screwed me. He did fix it but now I have 12.3v at best. Is there a way to diagnose this problem? I have all the maunals.
Just as I went to order a skeggaurd I broke my skeg. There is very little left so I don't think that I can bolt a new one on so I was looking the weld the old one on. I took the prop off, drained the oil and wanted to know if the seals and gears can handle 750F? Is is difficult the change the...
I have had the boat for several years and I have done all the service on it and it ran beautiful till the day. The starter went, so I put a new one. It will not start anymore. I checked everything and found it to be no spark. I checked with the manual to test everything so I decided to change...
Well as i am restoring this 17 capri cuddy i noticed that there isn't storage under the either back-to-back seats.can it be cut into to make a storage spot and has anybody done this?
I have just about finished my 89 cuddy Capri with 85 force.I can believe it is the same boat.When I got it it was left for dead and it was given to me and at the time I was no boater by any stretch.Well I finally got the ambition to get it out of where it was and it had rotted floors,bird eaten...
Hello all, I have installed a temp gauge and the only sender unit I found was one that sits on top of the block but it is not measuring the temp correctly.It is 20 degree off.Is there a better sender unit that I can purchase?
Well, problem #2.I wanted to service the trim and check the oil level and a local Marine shop said that AFT was ok to use in the trim.Well I added some and now the trim creeps down very slowly.I then called force manufacture(now Mercury) and they said to use 20 non-detergent oil.I flushed the...
Hello all, I am having a issue with my motor that is driving me crazy.At idle the engine starts to overheat.When I rev the engine the temp drops.I have a relatively new impeller which I checked recently.Is there something I am missing?
