Recent content by Maraian

  1. M

    05 J15 2 strk water passage grommet

    Does anybody know the exact location of pn 345188 (#5 in Cylinder diagram). Its a water passage grommet. Diagram does not show exact location. It looks to be near exhaust cover. I pulled the cover and dont see it. I ve got a hot head at higher RPMs only and already gone through the head, pump, t...
  2. M

    2006 Johnson 9.9 CYL Head

    Did you ever figure out this? Or where is 345188 grommet located?
  3. M

    Timing specs 2006 15hp 2stroke

    Won't idle. It was running good above idle until recently started missing and stumbling. Rebuilt the carb. It's got good spark and compression. Thermostat replaced end of last year. It's pumping water. Replaced water pump over winter. New plug wires. Grounds are good.
  4. M

    Timing specs 2006 15hp 2stroke

    Can anybody tell me What the timing should be at idle? Wot? Can't seem to find this Info. Is it measurable with timing light on this motor?
  5. M

    Measuring running temp

    If I point the meter on the thermostat cover it was like 125-135. The top of the thermostat housing was about 150. Cylinder head was all over the place from 90 to 197 at different spots.
  6. M

    Measuring running temp

    Where exactly should I point my infrared thermometer to determine correct running temp? Everywhere I point it I get a different number? Thx
  7. M

    Fuel pressure and restriction

    Does having normal fuel pressure at the Throttle Body (TBI) at idle and under load and WOT, rule out fuel starvation? Or is it possible to show normal pressure and still have a fuel restriction?
  8. M

    Different ground readings on batteries

    I was testing to see if I had a good ground and I got two different readings on the two batteries. One battery gave me 0.3 ohm. The other battery 6 ohm. Is this normal?
  9. M

    Motor Boggs down to half throttle after wot for a few minutes

    Then after 20 minutes of low rpm, I am able to full throttle again for a few minutes? anybody experience this problem? 2006 15 hp 2 stroke tiller
  10. M

    Will pressure washing strip non ablative bottom paint

    My boat has been in the water but not been used in three weeks. Built up a fair amount of crud. If I pull it to pressure wash clean will it also strip my non ablative anti fouling Paint?
  11. M

    Removal exhaust Gas recovery/re circulation line 98-01 merc 5.0?

    Has anyone removed the EGR line from the 1998-2001 5.0 or 5.7L? Any know problems?
  12. M

    Connect a shop tachometer to a 1998 Mercuiser 5.0L

    How to Connect a shop tachometer to a 1998 Mercuiser 5.0L bravo 2 bbl Distributor Thunderbolt V ignition?
  13. M

    Replaced exhaust, now overheat at wot, clogged Y exhaust tube?

    Re: Replaced exhaust, now overheat at wot, clogged Y exhaust tube?
Top