Thanks for the reference. That is close, but missing the fuse panel. I’m assuming the +12v goes to the fuse panel and the negative lines also go to the fuse panel. Also, since the bow lights on the pontoon is actually 2 separate lights im not entirely sure if they are wired in parallel or...
Real purty, and simple….as you might guess, I did it myself….should have asked an 8 year old to draw it, lol!
I’ll have to check the switch in the morning. I’ll include a picture if I can.
I’ve searched and searched. Honestly. But I cant find a simple diagram showing the wiring for navigation lights that include separate port and starboard lights, stern light, switch, fuse panel and battery. I know the wiring of the switch itself will be some what dependent on the type of switch...
I’ve solved my problem from the below thread (sorry, not sure the best way to link the thread)
The solution is called a 2022 Suzuki 50hp. works like a charm now!!
(the bank is happy too!)
https://forums.iboats.com/threads/still-still-stuck-with-no-spark.765059/#post-5846684
It’s the black 16 amp stator for reference.
At cranking speed on a fully charged battery on low speed (blue wire) it is 245. High speed (red wire) it is 15. My rpm gauge isn’t working so I’m not certain of the rpms. Service manual calls for low speed 160-200 @ 300 rpms and 315-385 @ 1000 and...
I checked the ground wires for the coil. Each coil has its own ground wire. Two are attached to the upper mount bolt and two to the lower mount bolt (mount bolt for the switch box). These are securely attached. Thanks again for the suggestion.
Thanks. Ya, my new switch box has that ground wire also. I attached it to the mounting bolt for the switch box, along with the other ground wires for the coil.
Thanks. I’ll check the ground on coils. But if I remember, each coil is individually grounded. All coils have no voltage.
Ill check the trigger again and also trace the wires To check them.
Thanks for the additional leads!
Thanks for the suggestions. yup, I’ve removed the black/yellow from the switch box.
regarding the multimeter, I bought the DVA to attach to the meter in order to read the voltage. Voltage from the stator is good. No voltage is coming out of the switch box into the ignition coil.
Hi all.
I posted a thread about this last year and still struggling with it, so reaching out again for help. I’ve done additional test steps, but to summarize:
On my second trip out on my new to me 1996 Mariner (see signature for detail) my engine just quit. No sputter, coughs or bangs...
Thanks for everyone’s input!
Winner was…….the sending wire got disconnected in the engine compartment, likely when I was replacing the steering cable last year!
Your help is much appreciated!!
On to seal kit replacement of the upper gear case. Damn, will the ever end!!!
Hey amplay. I had the same sort of problem last year. Would idle ok, troll speed ok but when I go wide open it would stall out then hard to start. Once I got it started again, the same thing would happen all over again.
Im almost positive it was water in the gas. I put a full can seafoam in the...
