Greetings again.
Ok need advise. We got it apart and inspected everything. Is there a difference between these two clutch dogs? Also is there a difference between the forward and reverse gears? The clutch dog on the left is the the one that came out of the lower unit. The one on the right is a...
Gentlemen
Greetings.
Is there any specific tools needed to disassemble the lower unit? I don’t own the manual at this time either. I am going to help its new owner/friend solve this problem. Never serviced a lower unit that far in. Part of the repairs I’ve done already include the water pump...
Can you circle the parts in question on the diagram for me so I know what I’m looking for? Also would there be evidence in the gear oil if damage to said parts?
I have no idea how this happened. It ran flawlessly for me the few times I took it out. Probably drove the boat 6 times throughout the repairs I did to get it running. He bought it from me at the end of the winter without test driving it.
I had no reason to believe it wouldn’t drive as well as...
Greetings. Racerone
Can’t figure out how to pm you directly.
I have a new problem. Im hoping you might be able to help me with. Here’s the story. I ran the sprint twice last summer. I put the boat away for the season early. Decided to sell the boat and it has a new owner now. The gentleman who...
I bought the complete seal,housing,bearing assembly last fall because it was cheaper than just buying the seal and bearing separately. Rebuilt everything and filled it. Was planning a last boat ride in the fall. I came out the next day and there was a gear oil puddle on the floor. I walked away...
Did not do pressure test.
Spring is in the correct position.
New o rings on the 4 screws.
100% it was new gear oil.
Was thinking of polishing the shaft. What about the large o ring on the assembly/housing? I’m assuming it is a back up in addition to the shaft seal? The shaft is still...
He all.
I’m back with more questions on my 67 Evinrude. 80 hp lower unit. I have completely rebuilt it with all new seals because of water/oil contamination. After assembly and fresh oil, I lowered the engine, left it over night and the gear case oil is slowly dripping out. The prop shaft has...
Greetings
The Boat is a 1967. I was wondering why someone would want to glass over the bilge pocket? Im thinking I might have to open that up next spring to investigate.
Thanks for your input.
Greetings everyone.
Was wondering if this floor and interior are original. Also wondering is the floor covering original? It looks like the same material that is used for above ground pool liner? I also have to repair the rear 2 feet. It’s a little soft in the right rear corner. Any suggestions...
I know your right. That’s gonna have be next seasons project. The Snow is about to fly here in VT. Time for ice fishing soon.
Thanks again everyone for all the great input.
I got the cable out and opened two small windows in the cable with a cut off wheel. Cleaned it out with brake parts cleaner then some PB Blaster. Took a few hours. Back and forth, back and forth…..Seems that only the last two feet were effected by the grease pumped into it over the years. It...
