Current visitors

Home
Members

MikeSchinlaub's latest activity

M

MikeSchinlaub reacted to redneck joe's post in the thread 82 Starcraft MR 180 floor, slight refit and leaks with Like.

I see you've met my second wife.... Also not planning to dig out along the stringer unless there is a good reason.

Mar 28, 2025
M

MikeSchinlaub replied to the thread Prime and Paint Aluminum Boat.

Ok I read your post again, because I was at work and distracted the first time. So grey on the bottom, blue sides. Where does the...

Mar 28, 2025
M
MikeSchinlaub replied to the thread Prime and Paint Aluminum Boat.

First, I'm imagining two colors on one surface, like blue primary with a gold stripe. What I'm picturing may not be what you intend...
Mar 28, 2025
M

MikeSchinlaub replied to the thread 82 Starcraft MR 180 floor, slight refit and leaks.

I would scrape it out in pieces. Grinding it out is going to make a huge mess that will stick to you like crazy. Foam dust is really...

Mar 28, 2025
M

MikeSchinlaub replied to the thread Prime and Paint Aluminum Boat.

I'll get back with you after work.

Mar 28, 2025
M
MikeSchinlaub replied to the thread Prime and Paint Aluminum Boat.

A quick bit of advice for masking a hardline. Do your big area first, leaving a small bit of unmasked surface above it. Finish with one...
Mar 28, 2025
M

MikeSchinlaub replied to the thread Prime and Paint Aluminum Boat.

Avoid the rivets with the da, just lightly hit those by hand. I don't think you really need the heavier grit for the bare spots, but it...

Mar 28, 2025
M

MikeSchinlaub reacted to SlipperyOar's post in the thread Prime and Paint Aluminum Boat with Like.

So I've went and gotten myself some primer, i went to a local auto body supplier who have supplied painting supplies to our farm before...

Mar 28, 2025
M
MikeSchinlaub replied to the thread 82 Starcraft MR 180 floor, slight refit and leaks.

Sorry I didn't help with the foam. I haven't gotten any notifications for this thread for some reason. These are my usual tools for...
Mar 26, 2025
M

MikeSchinlaub reacted to Pmt133's post in the thread My 84 4winns horizon 195 project. with Like.

Again... not my finest work, but not too bad either.

Mar 25, 2025
M

MikeSchinlaub replied to the thread My 84 4winns horizon 195 project..

"Finest work" isn't the important part. Is it comfortable? If so, then it's perfect.

Mar 25, 2025
M

MikeSchinlaub replied to the thread Boats from work..

I agree 100%.

Mar 25, 2025
M

MikeSchinlaub reacted to Pmt133's post in the thread Boats from work. with Like.

In the sense that they cut the same corners that all the "higher end" consumer models do. Better than most for sure but I don't think...

Mar 25, 2025
M

MikeSchinlaub replied to the thread Boats from work..

The boss did say the out drive had to be replaced.

Mar 25, 2025
M

MikeSchinlaub replied to the thread Boats from work..

Really? I've usually found Cobalts to be pretty well made. I've never seen one with a large area of bond like this.

Mar 25, 2025

Show older items

Home
Members

Top