So the bearing is gone. Snap ring goes on the inside lip of the carrier housing and holds seals/bearings in place.
The yoke is indeed held into place with a washer and bolt which obviously sheared off.
Gears look good and from what I can tell the metal shavings are from the bearing.
Is it...
So the snap ring 10 holds that in place? Haven’t found that yet. Time to tear it open. 11 is the seal which you can see in the pics above are junk. Hoping I can maybe get a new seal and snap ring and hopefully the bearing and gears aren’t junk… highly unlikely I know.
Hauling the boat out for the winter I was on my way to the ramp and heard a thud and the engine died. Tried to get it started again and it wouldn’t turn over. Thought I may have hit something or picked up some line. I lifted the drive and nothing in the props. Tried again and got it running...
So I have the serial number for both the drive and the transom assembly. Is there a site I can use to enter the serial number and find correct parts?
Thank you again.
I cannot find the correct part number for the gimbal bearing for a Dpsm. If anyone has a part number it would be appreciated. I am not looking for the new greaseless one. I would like to grease it. Also, stripped the zerk fitting out of the plastic tube so I am looking for part numbers for the...
**Update.
I learn a lot about boats in forums such as this. Doing research it bothers me when there are ideas given but the op doesn’t give the final results to tell what worked/didn’t work. So here we go…
I went with Bennett marine 12x16 sport tabs. I wasn’t sure if it would be enough for my...
That’s good info. 2550 is pretty close in size. Trying to keep the width as shallow as possible for easier and better mounting position and was looking at the sport option. Idk about wanting a double piston but was looking at the xpt model. A bit more pricey but just another question to ask...
I’m actually leading toward the hydraulic system now and would love the m120 which is hydraulic. Says for boats up to 23feet though so at 28 I’m not sure it will be enough even with the 30% more lifting power as advertised. Curious what Bennett has to say.
Ok. So I don’t need to be perfectly parallel with the bottom. I’ll obviously call Bennett on Monday to see what they suggest but that is an idea. Thanks.
