Now that I am thinking about it and researched it a little. Is it possible the sea water circular pump on the engine has failed or is failing? Trying to also determine if the water pump is before or after the water pressure sensor as far as flow?
I'm looking for a bit of guidance and a fresh perspective. I do understand the issue should ultimately be diagnosed via computer, and I already have that scheduled.
The problem arises at around 3500 RPMs, where I get a single, constant alarm along with a slight reduction in power. When I reduce...
Yes, the water pressure is way too low, what doesn't make sense is that if the water pressure sensor is faulty, I would expect that it would throw a code and that the engine temperature isn't anywhere near what it is supposed to be. Which is throwing me for a loop. I ordered a new water...
So I connected my vessel view and ran it under load and took multiple snap shots. I am getting an alarm at idle when I first start the boat and again above 3500 rpms. The oil temperature and engine temperature, I believe are very low. The other concern is the water pressure is also very low...
2007 engine. Engine has been scanned with a scan tool. Everything checks out. I am trying to find where I would find the plug that goes into there. I can't find a wiring diagram, which I am trying to find for the plug
Attempting to find the wiring diagram for this? I have looked around and can't find the plug that would is supposed to go in there. Any assistance to point me in the direction of it would be greatly appreciated as I'm running into the issue below.
I am getting a single beep alarm at idle and...
All-
I posted previously about receiving a single alarm at approximately 2000 rpms on a 2007 Sea Ray Sport 185 4.3 L Fuel Injected engine. Fast forward and I have now replaced practically every mechanical and electrical component for this boat that could potentially cause the alarm (water...
