Does anyone know if there is a fuel pump that can replace the vro pump and are there any other items that need to be plugged, disconnected , removed
The pump is plugged at motor area ,plan to remove vro tank .If this is possible to change to a fuel pump what part number is it ? , do we need to...
Good afternoon hopefully everyone is well
have a new project and a new problem motor runs fine on a hose or idling in the water but is soon as you throttle up the motor bogs down but eventually dies any help here would be greatly appreciated
Can anyone tell me how to size a prop
There are no numbers stamped on it except Michigan
142003 when I look it up on iboats it comes up as
A prop for a Nissan nothing about a force I'm pretty sure this prop is a original to the boat and motor
The RPM s seem to be very close it planes ok...
Does any one know if Michigan part number 142003
Is the correct prop for our 70 hp force 1991 1995 engine when I looked it up on iboats it came as a total different engine make .also what does 10-3/10 for diameter equal and what does 12-7/10 for pitch is this the correct prop or are they using...
Thanks for your help last time guys I lapped the flywheel replace the keyway ,locking nut ,torque the flywheel to 85 foot-pounds we trolled for six hours caught 17 striper on the way back to the launch the flywheel Spun again what are the chances I can get a new flywheel or replacement...
The keyway has sheared and was wondering if any
Other damage could have happened .i know it has
no valves but ? Also what caused this ?carb issue ?/
timeing ? Fuel is fresh and mixed correct or is it
possible we did not tighten the flywheel nut correctly when new
Stator was installed
Cannot get the King pin to budge removed the
Kotter pin tried to tap it with 3 lb hammer several
Times with pbblast soaking still no movement
Any help would be great trying to ready for fall striper but cannot get trim ram out its 96 force Mercury 70
