Manual indicates that these adjustments should be made while tied to a dock. I realize that this would be ideal but can you get close enough using a flushing device then make final adjustments in the water? Thanks
I haven't used a tachometer for many years. I want to check my idle speed with a hand held tach. I believe that one side goes to the positive side of the engine coil and the other to ground. Is this correct? Thanks
I have a Clymer manual it tells you how to adjust the air mixture and idle adjustment on some models but on a 1998 Force 120 I can't seem to find any adjustment screw other than possibly an adjustment to the Throttle cable or linkage. Is this were the adjustment would be made to increase your...
Most Trim tab have instructions on how far from the outer edge or from center tabs should be installed butI am having difficulty in finding out if there is a minimum thickness a transom should be to install these tabs. Is there a thickness that would not be recommended for an install? Thanks
I have the above horn on my boat. It no longer works but has a lifetime warranty. Can anyone<br />tell me how to reach the manufacturer so I can return this one for one that works.? Thanks
Has anyone found a less difficult was to install<br />a starter in a 305 Mercruiser when it has to be done basicly by feel? I seem to be having problems<br />aligning the bolt holes while holding starter. ie Like putting something in the bolt holes so the don't slide out etc. Thanks
Other than not lasting as long as a marine starter<br />are ther any regulations aganist using an automotive starter in an I/O.<br />Are they considered that much of a safety hazard?<br />Thanks Paul
Does anyone have a photo of this starter showing the location of the bolts to remove to replace same. I can feel two bolts under the starter but can't tell if they are the only ones or if there are more at the top.If you have no photo but have the info please reply. I have a manual but it...
My fuel gauge isn't working, Is there a test one can perform to determine whether the cause is the gauge or sending unit? If so please guide me through. Thanks much
Only had boat a short time . Removed gear housing to replace impeller on water pump Now I am having a problem shifting gear box to forward gear and pushing it back up into leg. The shift rod seems to turn only one way but after installed it dosen't shift into neutral or another gear. Should the...
