Question:
Evinrude 135 bad timer base. Tested properly per the CDI instructions using DVA adaptor. SO. The question.
The timer base replacement is expensive. The timer base itself is in good condition. WHERE can I purchase JUST the Trigger coil pick ups. Or some my call the Pulse trigger...
Trying to resolve tire issue with old trailer.
Have Old tires (609/600-9) on 5 -5.5 hub (Old lug spacing is the problem)
Axle is 1 3/8" straight.
I can find bearings for hubs.
I can NOT find hubs with that lug pattern
I can NOT find and I WANT hubs with 5-4.5 Pattern so as to use standard...
Re: 1975 evinrude 135 extra ingition part?
Ok Here is a picture of the part this is the forward side which mounts up against a metal plate that is mounted to the cylinder head. I think it is a temperature sending unit. Anyone have a clue?
working on the famous no sprak issue. Decided to remove all parts and clean up and check wires.
There is an extra part not shown on any schematic i can find. It is a small fused box bolted to the head on the port side lower piston of the engine. It is aluminum with a resin sealed back. What...
Just completed a rebuild. Seals, gaskets top and bottom. Came with electronic ingnition. No. one cyl has no spark when testing with a timing light and pulling the start cord. swaped the ingnition modules with each other and still no spark on no. one. Swaped coils with each other and checked...
Please Help. Parts will be in before this weekend and I still do not have the manual. This motor is my sons and I would like to start putting it back together this weekend. I need:
Torque specs for the CAP SCREWS on the connecting rods. CASE SCREWS on the case, REED COVER AND EXHAUST COVER...
My engine is coming along although still having problems with getting high RPM after 2 or 3 short runs.
When I got engine did not run. Replaced stator and BAD rectifier and rebuilt the carbs. Ran OK for about 3 - 3 min runs then wont get up on plane. (wont accel past a fast idle). So I replaced...
Got the engine running great 130 psi all cyl. Problem is just burned up my 3rd starter. First one was original, second one the store said they are making them cheap now and replaced free of charge. Now that one is toast. I heard the bendix not engaging the flywheel properly, Keept trying to...
I removed the 10 head bolts. All were very rusted in 3 of them I had to grind off the bolt heads but the head will not budge. I am getting frustrated and don't want to damage the head. Are there other bolts besides the 10 head bolts? If not then what do I do to get this head off?
Old 1975 evinrude 135. Had starting problems and replaced stator and rectifier. But then thought I killed the battery trying to figure this out. Got a new battery starter would jump into gear (bendix engage with flywheel) but then would not turn over maybe just one thump (one cylinder). Got a...
I am trying to get my project Evinrude 135 running. Had it fire only two bursts on the second day of cranking the engine and looking for possible fuel problems. Hooked up a timing light and saw no spark. It sparked a couple times fired then died. Nothing since. It looked like the Stator coils...
