Recent content by PSim

Thank you. Hopefully there are some experienced members here that can offer tidbits along the way. I'm relatively seasoned DIY'er in plenty of areas but experience on details is hard to beat.

Pretty much fully ready for sanding prep before new transom and glass. Boat is level with some supports inside to prevent any hull shift. With the floor intact, I doubt any twisting will occur but might as well play it safe anyway. I also did not expect a keelson board but it shouldn't be too...

Took the top skin off to make it easier to work on the transom. Bit of a PITA since there are a bunch of rivets holding the skin on, which is after taking off all the fully rusted t-Bolts holding on the aluminum rub rail. After that, just chipping away at the rotten transom and stringers. A bit...

Hey guys, I go by P. I've reading the forums for years so I figured it was my time to give back in a way and hopefully give a few inspiration to go and attempt this work themselves. Me and a good friend each bring some assets to the table so we decided to go in on this small boat as a good...