Model # S130 TLRU
Recently i had an issue with the oil injection and have rectified the issue i am sure this is a temp sensor problem.
Ok here it goes while running the boat at 4200 + rpm's the alarm would sound and the motor would go into limp mode, so i have begun my investigations. i...
Ok I have spent days reading and testing everything that has been posted on here about the precision blend system. I am very mechanically inclined and have not found the issue yet . here is the sympton
Just purchased a flats boat and it runs great i have no issues at all . after a few moments...
i have the 454 out of my boat and rebuilt it . after all the machine work and assembling . it is ready to go. i turned the crank over by hand and it does not rotate the entire way. i then proceeded to pull the valve covers and take the pushrods out. it now turn over fine. my question is there...
i bought a 28' silverton it has a single 454 and a v drive for the trans. i disassembled the motor and it has been rebuilt before. it has a large cam gear to a single crank gear . this is reverse rotation. my question is that with someone being in the motor, probably more than once is it...
i have a nice 79 mako 21 it has an Evinrude Ocean Pro 175 the problem is i am having issues with the thing porpoising it takes a long time to plane maybe 8-12 seconds. once on plane it runs great except for when i hit a small wave maybe 2-3 ft it starts to bounce and will eventually settle down...
thanks for looking i appreciate all input on this issue.
I have a 95 Evinrude 175 Ocean Pro . it runs great when running. if i use the boat and then let it sit for a few days then go to use it again . it is a heck of a time to start it. takes forever. just the other day i ran 100 miles in it...
ok here it goes took mariner inline 1997 motor apart and seized a ring to the piston.; the problem is i can not find the piston i need. the motor is
1997 mariner 4 cyl inline 125 hp
the motor has been rebuilt before and the bore is .030 over now . the piston that came out of it says
"582" on...
ok had wiring issues with this boat . so anyhow got them straightened out today . everything works it starts stops and so on . put it in the water for fishing trip in the morning . starts right up everything good and ready . all of a sudden i notice i am not charging. i did install a new...
my 95 evinrude ocean pro 175 just developed this problem . it starts runs fine and has no issues other than it will not shut off. i checked the lanyard and disabled it ran it to a toggle to shut it oiff for the time being so i could use the boat . but it does not always work. sometime it will...
. hello every one ,
decided to get my mako it has an evinrude ocean pro 175 (1995) ready to run this weekend and take her out. everything has been fine with it , have had it several times no issues at all. yesterday i hooked up the tach and volts as well as water temp gauge . everything was...
Hello to everyone on this site i am newly registered here but have been reading the forums for years.
I have a question to pick your brains,
i just recently purchased a 19' trophy center console with a rebuilt 125 mariner on it. Yes i have the paperwork and talked to the marina that did the...
