Recent content by rbronston

  1. R

    Tohatsu

    So far I changed the fuel filter. But now I went out it still did t he same thing but even worse now it wont start at all.
  2. R

    Tohatsu

    Hello I have a tohatsu 15 hp . After about 10 minutes of running it bogged down. Then I have to pump the bulb again. It will run the bog down again. This continuous. Any idea what the problem could be. I got a new hose and it is still doing it. Thanks
  3. R

    Tohatsu. question

    Hello, I am a beginner at outboards and I noticed that when I go to flush my motor after being out on the water it doesn't pee. This is not a problem on the water only when I flush it regardless of if I use muffs or submerge it into a trash can of water. Is this something to be concerned about...
  4. R

    Engine cutting off

    Yes it has the Manuel vent opened.
  5. R

    Engine cutting off

    2019 Tohatsu 15hp
  6. R

    Engine cutting off

    Hello. Can someone give me an opinion on why my motor dies after about 5 minutes of running. I notice that when it dies I try to prime the bulb and it won’t pull gas from the tank. After I get home and has sat I try and it primes. It’s like once I start it and get moving it isn’t pulling gas...
  7. R

    Engine cutting off

    Hello, Im new to owning a boat. I have a tohatsu 15 hp that primes,, starts and runs fine until about 10 minutes of running then it dies. I noticed when it does this the bulb will not prime at that time. I feel like the engine is getting gas. after I wait a while maybe 20 minutes or so it will...
  8. R

    Trim and tilt question

    It runs but comes out of the water. And I have to trim it waaaaay down
  9. R

    Trim and tilt question

  10. R

    Trim and tilt question

    So the holes that would be there after I remove the plate. I would just fill them marine sealant? Like I said this is all new to me man. I was actually thinking of trying to add a lower plate to the existing plate just lower. Don't know if that'll work. I'll have to think about it for a few and...
  11. R

    Trim and tilt question

    It’s trim n tilt. But it’s mounted so high the propeller is high damn near even with the bottom of the boat unless tilt it down a ways
  12. R

    Trim and tilt question

  13. R

    Trim and tilt question

    It only tilts down and up. It does go down and up vertically.
  14. R

    Trim and tilt question

    Hello, Im new to having a boat. I have a 14 foot jon boat. The previous owner put a electric tilt and trim plate on it. the plate has the motor sitting high. High enough that the the prop is almost at the level of the bottom of the boat. It has to be trimmed way down. is there any ideals on...
  15. R

    Any Sea nymph owners here?

    What are the switches one the console that are not the Blidge. Horn, live well
See more
Top