I took lower unit from 470 merc and put on 140 upper. And I left the 17p prop, cause it was in better shape. Will it do alright on the morphed drive? The boogered up lower from the 140 had a 21p prop. The diameter is the same. Thanks
This is a '96 40hp ELPTO merc outboard, 4 cyl....I pulled the hose off the oil pump where it comes out to mix with the gas, and turned the motor over several times ( with oil in cylinders and plug wires removed) it is not pumping any oil out. I am not familiar with these oil injected 2 strokes...
A friend brought me a '96 40hp merc outboard, to try and get it running for this spring s fishing. It has been sitting for 4 or 5 years. I have the motor running , but. the leads going to the trim motor were sadly lacking in insulation. So I suggested we fix the raw wires. After pulling the top...
I have a 1977 140/ 1.98R and I might get a 1978 470/ 1.84R outdrive. Are any of the parts on these 2 models interchangable. Or could I just switch out the whole sterndrive, ie, the 470 to replace the 140. The 470 came off a 6 cylinder and mine is off a 4 cylinder GM. Just need to know if it is...
I recently obtained a 14' correct-craft boat with a evinrude 25HP. Going to make a gator boat. Boat is in fair shape, but motor needs some work. I've got a mess of loose wires. I need a service manual and a wiring diagram...
The model # is E25ECIB the ser. # is E0001245 any help would be...
Does anyone have or know a link to get an exploded view pic of a delco-remy single wire alternator? My motor is a 140 GM 181 c.i. 1976
Is this all that is required on this alternator, one wire( a red/white wire) and a ground? There is a single rectangle opening on the side near the back,, where...
I need some help on this lower unit. I have the bearing carrier out (it needs to be replaced), but , how do you get the drive shaft & pinion gear and the prop shaft and gears out of the housing? Also, how does the reverse gear separate from the carrier? Thanks for any input on this.
I'm having problem separating upper drive from bell housing.
I removed 6 nuts and have shift shaft facing forward in drive position.
Is there something else I need to do to get this booger off? I don't want to force anything, but will only separate about 1/8".
Is a 1977 pre alpha 140 mercruiser...
Hello, I have a 1977 stingray w/140 mercruiser serial # 4661246
Is a 181 ci. 4 cylinder. Does anyone have a wiring diagram for this I/O
I have a mess-o-wires and don't know where they go?
Any help is greatly appreciated, thanks.
A guy recently gave me a 1977 stingray w/mercruiser 140. I removed vent and fill plug in lower unit and nothing but dirty water poured out. Prop housing has about a 4" crack in it, from the end inward. I am going to disassemble and see what goes. Is this crack repairable or will I need a new...
