Recent content by roonie

  1. R

    VRO delete fuel mix ratio?

    Well, I think I found the issue on the cylinder....I pulled the brown wire leading to the coil...a bunch of dust/corrosion fell out.that'll probably fix it 🤞
  2. R

    Fantastic for cleaning vinyl

    Fantastic...I just used it on my boat seats... ITS FANTASTIC!! I make no money and not affiliated with fantastic
  3. R

    VRO delete fuel mix ratio?

    You see the far right plug is white while the others are tan. That white plug comes from a hole that is 10# under 120psi...maybe less than 10# (lbs) only
  4. R

    VRO delete fuel mix ratio?

    I must apologize...my bad. I was trying to go by memory. It's not the ground wire...it's one of the 2 black/yellow wires coming from the ignition.one of the 2 black/yellow stripe wires has been capped off
  5. R

    VRO delete fuel mix ratio?

    racerone....that black/yellow wire i mention has been disconnected for years. i bought the boat that way.when i purchased the boat ,not running, maybe 15 yrs ago the wiring was a bit messed up....i did find a diagram back then....thats what got the boat running yrs ago. I do recall the...
  6. R

    VRO delete fuel mix ratio?

    Thanks...no Harbour freight where I live but I get your drift. i just found out I have one new plug (ngk BR9hs10) not tan like the other 3.they were out of champions QL77JC4 so he gave me ngk
  7. R

    VRO delete fuel mix ratio?

    1986 johnson 90hp 120 psi x4 I have deleted the vro. It was running and starting better than ever since vro delete...But... Shortly after delete its struggling to get up and go (hesitates badly)but eventually does clear and go once the speed increases...and when it does get up,seems to run fine...
  8. R

    Best fuel stabilizer for older 2 strokes

    I've been told that by having 2 stroke oil in the tank will stabilize fuel🤷‍♂️not sure if it's true or not
  9. R

    1986 90 hp johnson idle and ramp up issue

    The compression value is 120, all 4 cylinders. The engine has been rebored,rebuilt right before I purchased the boat about 10 yrs. Ago I can see where the engine previous to my owning, got hot (paint peeling off engine block)(some of the plastic protective sleeves that are over the wiring...
  10. R

    1986 90 hp johnson idle and ramp up issue

    Bump..,anyone?
  11. R

    1986 90 hp johnson idle and ramp up issue

    I've had this issue since owning the rig. Starts well but kinda shakes,feels like it's being held back until i start to get the boat moving,then smoothens out.its always done this. new issue...... The engine also will,at idle, rev up rpms on its own,then cut out like a dead short for a split...
  12. R

    1986 90hp johnson primer bulb collapsing..hear me out

    ......I have one other issue but I will start a new thread
  13. R

    1986 90hp johnson primer bulb collapsing..hear me out

    Yes over the pulse port.this pump has only 2 hose att.,fuel in ,fuel out .i don't have the # at this moment ,I'm at the lake
  14. R

    1986 90hp johnson primer bulb collapsing..hear me out

    Well, I'm reporting back with an update. I've purchased a Sierra non vro fuel pump and deleted my vro. The switch over wasn't too bad of a job.two hr.job. I also installed a new primer bulb and lines from tank. Zero smoke, starts right up with the touch of the key(it's never done that). My...
  15. R

    Opinions on aftermarket johnson/evinrude parts

    I'm like everybody else, trying to save a buck. Switching out my vro to a manual fuel pump. I would like to hear some opinions of aftermarket parts?....even Sierra compared to others.thanks
See more
Top