I'm replacing my Chev 305 with a Ford 351 and was wondering what I need to do to mate with my existing Mercruiser outdrive. Will a OMC bellhousing bolt up to a Mercuiser and what spline coupler would I need?
I was wondering if anybody has changed there idle jets leaner, if so are they air jets or fuel jets as far as going bigger or smaller. My motor loads up at idle after 5-10 minutes and I thought I would lean it up a bit.<br />Can I get different jets at my dealer?
Does anybody know if they made one in 86'? I need the 60hp decals to replace my 86' 40 hp decals. Does anybody know where I could get those, I checked my dealer and they said I couldn't get them.
Anybody know what the timing should be at a idle for a 84 60hp? The reason I ask is the rod that links the carb to the stator assembly was bad and I need to adjust it now.
I have a few questions I hope you guys can help me on. The motor is a 84 Evinrude 60hp.<br /><br />1.How far does the lower unit have to be in a barrel of water to pump? Is it the same holes you would put the rabbit ears on or the holes above those?<br /><br />2.How do I adjust my timing as far...
Does anybody know which jet is the idle jet on my 84 Evinrude 60hp? Is it the one right above the throat of the carb like my manual says or is it the one where the carb bolts to the intake like the Evinrude dealer said? The reason I ask is I put Boyesen reeds in and I need to jet it richer.
Does anybody know where I can get a carb for a 1984 60hp perferably used. Mine has a bent throttle shaft and the dealer can't get just the shaft. My carb # is 394809....Thanks!
I just put in a pair of boyesen reeds on my 84 Evinrude 60hp and it said to richen the idle circuit. I went to my evinrude dealer and they said all they can get are the stock sized jet. Does anybody know where I could get a couple?
Does anybody know where I could get the decals I just want the 60 hp decals. Also what whould the T stand for in the model# in place of the E for electric start which it has....Thanks
My question is if the bore and stroke are the same between a 86 40hp and 84 60hp and the pistons have the same part# and the carbs take the same rebulid kit, how do they make 20hp?
I was wondering if anybody new if I could take a 86 Evinrude 60hp powerhead and put it on a 87 40hp motor. Also is there anyway to run a motor without the lower unit, to get it to pump water?
I was wondering if anybody new if a 1987 evinrude 40 hp lower unit will fit a 87 Evinrude 60hp?<br />Also is there any was to put the newer style trim and tilt on the older motor?<br />Thanks.
