I noticed the trim fluid, or automatic transmission fluid, is escaping from the top of my tilt seal and leaking down the unit. Is it a bad seal you think? How hard is it to do this myself? I don't have the best tools, and I'm not the most handy guy either. What am I looking at to have a...
Not so much creaking/groaning. People seem to think air or water is making the noise. Still trying to find time/light to open the screw and inspect what fluid to get. I sprayed some WD-40 on it and let it sit. Need a chisel or some other sort of tool. Widest screw driver I have is not wide...
I've read related posts and looked elsewhere first for schematic diagrams and manuals. Power trim has been slow to go up, then stopped going up altogether. Now it's slow to go down too. Battery is fully charged. Don't think it's the relays because it sounds like it's trying. Trim has...
2 questions. I replaced the diaphragms/washers in a VRO fuel pump versus swapping it out for a non-VRO fuel pump. I don't think the issue was worn parts because the old ones looked good. The problem seems to be the old fuel hose and especially a leak at the male fuel tank connector. I plan...
Still trying to figure out why the motor dies idling or at idle speed when warm. Through the process of elimination, and fixing just about everything else, I suspect it may be either an old fuel hose or diaphragm in the fuel pump, possibly both. The carbs have been rebuilt, new spark plugs...
Motor dies when idling in gear or neutral. Runs great when you give it the gas though. A retired boat mechanic told me to adjust the throttle adjustment on the carb. Please see the attached picture. I think my index finger is on the throttle adjustment knob? I suppose I would rotate it right to...
Just about had it with this outboard. Probably less than 200 hours total on this motor. Bought it from my dad after it sat for 6+ years. He took good care of it and I never remember it being so temperamental. Spent hundreds of dollars with a highly recommended mechanic rebuilding carbs...
Spent a lot of money getting this 1998 50 hp motor running again about a year ago. Spent 6+ years on a farm untouched after my dad gave it to my brother. I rescued it and needed a project. New water pump/impeller, rebuilt cabs, new spark plugs, new wiring, took oil injection off so it runs on...
I have checked the other posts and not seen a similar issue. Apologies if it's on an old page or been answered. Inherited a Seaark 16' jon boat from my old man. He bought it new in 1998 and probably put less than 100 hours on it total. It sat on a farm for 6 years before I got a hold of it...
