Recent content by Stingray1961

  1. S

    Weber change to Holley

    I have a 1993 stingray zp. 4.3 mercruiser Weber 4 barrel I want to put the marine Holley in does some one know if it's a direct bolt in or do you have to change the manifold
  2. S

    Stringers 1993

    I have a 1993 609zp what are the stringers made of
  3. S

    Ac delco conversion

    Hi guys I changed over from my thunderbolt ignition to the ac delco kit from Michigan it says on the paper work -4 with manifolds that have 12 bolts and 2 with 8 bolt manifolds for initial timing mine is the 12 bolt one I had a heck of a time getting the distributor to line up at one I converted...
  4. S

    Ignition control module

    805361t6 Does any one know if some one bedside mercruiser make on 1993 4.3
  5. S

    1993 4.3 lost spark

    I have been chasing many problems had most figured out set timing did not get enough total timing should be 25 to 29 only got 20 does the Module control that also now lost spark only 11 volts out of wire out of coil but if yiu wait an hour it come back then shuts off after 10 min any suggestions
  6. S

    4.3 down on power

    This year took the boat out 1993 stingray 4.3 mercruiser boat struggled to plain rpm won't come up. Rebuilt carb fuel filter changed new plugs cap rotor timing checked . Good compression any suggestions
  7. S

    Frosty oi

    I was just changing my oil in the lower unit mercriuser 1993 4.3 had done a pressure test this spring was good. When I was pumping the oil from the bottom vent hole at first it was clean watching it get pushed out the top vent hole. but as the oil that was lower down came out it was frosty.is...
  8. S

    Does my 4.3 alpha 1 have a impleller

    Does my 1993 mercruiser 4.3 lx alpha 1 have a impeller. If do were
  9. S

    How do you do a pressure test of lower unit

    I have a 1993 4.3 how to you do a pressure - vacum test. Specifically what hole, the drain plug
  10. S

    Milky lower unit oil 4.3

    Hi just changed my lower unit oil little frosty. Which seal would be letting water in. would it be the one on the shaft of the lower untit. The loiwer unit is only two years old.
  11. S

    Weber carb on 4.3

    I was told by dealer that it was very hard to get weber carbs to run properly. Does any one know if that's true. Do a lot of you guys replace them with holley or other brands. Please any input. Mine is a 4 b on a 4.3 mercruiser
  12. S

    coil mercruiser 4.3

    do you have to use a marine coil for a 4.3 or can you just get one at napa. Is there aq diff
  13. S

    Location of anti syphon valve 93 stingray

    Hi does anyone know the exact location for the anti syphon valve 1993 21 foot stingray 4.3 mercruiser.
  14. S

    4.3 weber carb electric choke hook up

    Two questions could some one tell me where to wire the wires on the choke for a 4.3 mercruiser. I replaced the manual one with a electric one not sure what to wire it two. i was told that weber carbs are known for not running right and its hard to get them to run right by a dealer. any one...
  15. S

    lack of power 4.3 mercruiser

    Hi I have a 1993 Stingray 4.3. I had the carburator rebuilt thinkin that was the reason power was down. That didnt fix the problem. Have new wires timing is advancing under acc. I bought a rebuilt from Flying Fish Carburators dont know if the carb is still the problem. Any suggestions.
See more
Top