Recent content by supercobra

Here is a pic of my shore panel on my 1991 310 sundancer.In previous post I talk about I can't get water pump on.But I don't understand what some of these switches are for? The AC converter button,what does it do? The red waste system control switch and the little black button to the left of it...

I bought a 91 sea ray 310 sundancer and can't get the water to come out any of the sinks or toilet.It doesn't have a switch in the shore panel area,all it has is a water heater switch. I filled up the tank and turned on the switch on the dash that says water pump and got nothing.Does it have a...

What is that screw for where it says oil?Do I add there or inside?I don't see a drain.

And what is that screw for oil for?Doesn't it get oil from inside?

What would be a easy upgrade?

So what drive is this?And does that prop look to big for the anode to go there?

What model is this?Can't see the complete numbers.also on the bottom it's missing that little fin deal that bolts there because prop is too big.Did someone put to big of prop or does a cap go there?It's a Baja force 250 with 454.Also what is that fill plug for on upper left side?I don't see a...

Bought this Baja force 250 with mercruiser 454 in it and replaced all gaskets .I also bought a parts engine to get parts and bolts from.Now after installing the original balancer it starts whining like a bearing is going out on a accessory pump.I then tried the parts motor balancer and it does...

Thank you

So would I install a thin plate and weld all the way around or just tack it in a few places?Does this have to be sealed off completely?And does it affect compression?or does it need to be just covered with a gasket and rtv around it like someone did before?

Block#14015445 Head #14081045 Parts motor Block#14015445 Head #14092360 Everything looks exactly same between these 2 engines.I am seeing mercury gasket intake 8m0050224 And glm marine 39170 both have a lot taller gasket in that port area to cover that hole.I bet one of those gaskets was...

I wonder if I can rtv all around it and seal it off?But is it a exhaust or water port?I guess it can't be water cause their is no intake connection.

I wonder if that's the problem it saying gen 5 by my gasket 17340?Surely it's not that ,but I would still have to rtv the gasket all around that area due to intake will not hold that part down on its own.o can also see on this parts motor the old gasket covered that area completely and had rtv...

So that number comes up as the original parts for this engine.down below or let's me pick a alternative equivalent gasket it recommend.but it does say gen 5 by part number 17340.

Engine didn't have tag for serial number.here is a spare junk motor that is same kind without the gaskets.intake is same as the one I have on my good engine.tpu can see it sits below the ports.i want to know is this a water port or is it a exhaust crossover?