Recent content by tayznild

I found some water in the trim oil reservoir. I think it is time to rebuild my trim cylinders. Looking for a rebuilding kit and a how to doit video or diagram.

I own a 2000 4.3 gi pefs. The raw water pump fail again. I need to know if there any mod to put a low cost water pump? Can i use a electric one? Or any other pump?

Ngk bpr6fs or bpr6efs?

trying to find trim parts diagram to know the part # of my trim oil reservoir tank. any web page for it?

when i put the control in forward it doesnt engage until i rev the engine. any idea the problem is? the cable is good condition.

my engine does not have the front timing mark, how can i timing?

looking for a x23 pitch prop and this are the only options in my budget, any advise please...

when i take turns or trim up the sterndrive vibrate and make noice. already inspect the u joint and looks fine. any advise please...

what is wrong? 14.25 x 21 prop. it rev easy to 4500. with 15 x 17 prop 30mph. does i need a 4 wing prop? 15 x 25 is the answer? any advise apreciated....

When i try to cross the 4700 rpm range the engine loss a lot of power sudenly. Any idea? 2000 4.3 gi engine

why manifolds need water. cars dont need it. if i move the manifold water hose to the y pipe, what can happen?

my boat overheating after impeller and water pump replacement, im going to make it thru hull water pick up. any recomendation in location or product type?

looking on the parts diagram from volvo , it seid that i need to buy the complete fuel pump system for around $700. is thet true. or i can buy the low pressure pump that i have dead, because the hi pressure one is in good condition. any help apreciated.

2000 4.3 gi pefs engine. how can i wire it to start it out of the boat?

i was lookin for a camshaft and only found comp cams for marine engine. does any body have aftermarket camshaft? it worth the money?