I have a problem with my 85 model 15hp Evinrude. I just finished some work doing a different head with the thermostat on top and new gaskets and thermostat, new water tube and water tube grommets, New powerhead to exhaust head gasket. New waterpump housing and waterpump. I have the motor running...
I was wondering if you can put a newer head like an 86 or 87 year model so I can get to the thermostat easier? It looks like the same bolt pattern just the location of the thermostat is different
Can you do this and cover the terminals and run the motor with out doing damage to the charging circuit? I am needing my battery to run the trolling motor and the instructions in the trolling motor say not to have the trolling motor on the same battery that the engine is on. They say the...
I have a Lowe 1440m that I am doing lots of work to on the inside. Decks on front and back , flooring and trolling motor. I have a 1985 Evinrude 15hp motor that is just the bomb. It has a 9 1x2 x 10 prop. I runs great and I could not ask for better. My question is will I benefit from a...
I hope you men and or ladies don't get too mad for me putting this here. I did not know where else to put it. I have had many outboards big, small, old, new I have never had an outboard motor that I am so proud to own. It is just so versatile, and easy to handle. It always ( and I mean always )...
Motor starts fine idles good runs strong, but when it has been running at wot or about 3/4 throttle when you are slowing down it will cut off. you can crank it right up and it runs fine then go for a 1 minute wot or 3/4 it will do it again when slowing down any ideas?
what parts do I need to get to get the job done right gaskets, bushings etc? I have an 81 service manual and that was the closest year manual I could find.
I have a 1985 e15rcob 15hp. The motor runs good and works great. I have started to do some maintenance that the motor needed and I am trying to change the thermostat on the little motor. I cannot get the head plate off to save my life. Do I need to lift the powerhead off to get this off? The...
