Recent content by travis37

  1. T

    recessed trolling motor foot control

    I own a pt185 bass tracker(2004) and am thinking about buying and installing a recessed foot control pan. I was just wandering if any of you have done this install on a boat like this. I guess I am also not sure if there is a support right where I would need to cut a hole for it. Any info would...
  2. T

    bass tracker setup

    I recently bought a 2004 pt185 bass tracker with a 04 mercury 75 hp 2 stroke. The problem is that it doesnt have much trim control. I think that the motor is mounted to high on the transom. I leveled the hull and measured down from the bottom(18 in). I then leveled the cavitation plate and...
  3. T

    merc.,mariner or force

    I might buy a 2004 75 hp motor with tracker colors and am wondering how to tell what it really is,merc, mariner or force . Is there an easy way to tell? should it tell me under the hood or will the model number be needed to find out? THANKS
  4. T

    75 elpto 2004

    Just wandering the max rpm at wot for this motor. And anything else you all can think of. maybe a good site that I can look up for more info s/n 0t856113
  5. T

    spark plugs

    just wondering how often you guys change spark plugs(hours). could old plugs be causing a high speed miss. I own a 92 175 thats been rebuilt.I plan on changing them but I was just curious.
  6. T

    '92 175 miss

    I own a 92 175 and am having a high speed miss or cough. Not sure what to do. I have went through the carbs already. This motor is a reman. block with 81hrs on it.Any ideas would be great. I also notice that when I am at idle my tach kind of jumps around a little but not real bad,could this mean...
  7. T

    OMC ignition analyzer

    while going over a link and synch in my service manual, it calls for a ignition analyzer for my timing. I do not own one of these. is it possible to do it using a multi meter and alligater clips. any info would be great. I have searched all over and have not found info on this matter.
  8. T

    idle setting ?????

    what should my motor (ve175glenc) be idling at? And is 92psi a good compression give or take 5psi ? THANK YOU!!! By the way, this site rocks for info:D:D
  9. T

    trouble idling

    I own a 95 evinrude intruder 175 and am having trouble with the idle. It will keep dieing off unless I push the choke in for a split second. if i idie around I always have trouble with this. can anybody help???
Top