Hello all
I was wondering what the difference of a Chevy 305 block in a car and a 305 block in a boat is there a difference or can I use a block out of a car to replace my cracked block in my boat thanks mike
Hello all
So as most of you know I pulled my cover off my boat a week ago and found ice up over motor.
After ice melts I get the motor running one time has not run since. I pulled my dip stick before to check oil it looked good now I pull it this is what I find to me this does not look good...
hello all trying to trace a wire on my motor not sure what the wire goes to it is broke here on this pic
and I think but not sure if it goes here or what it is for I think it may be for my trim
Hello all so I just went out to uncover my boat. and inside the boat the ice is unbelievable it has froze up the motor. the drain did not do a good job it has ice frozen up to my belts I assume this is bad anyone have this problem before thanks
Hello never wake board before and want to try but before I bought a board do I need a tower or a pylon I have 19 foot chaparral bow rider with a 5.0 merc motor
Hello all
So over the weekend I ran the boat out of gas and it is probably cause my fuel gauge don't work can anyone lead me in the right direction to help fix this problem like were to start checking for starters the boat is a 1985 chaparral xl 200 with a 5.0 merc any ideas were to start...
hello all
It's an 85 5.0L 230HP MIE Inboard model number 02301345 and the boat stalled on the water and when I spray starting fluid in carbs she starts and then stalls it does not appear to being getting fuel I think it is a fuel pump but I wont to double check first any good info would be...
Hello it has been awhile since I been on here I just picked up a 1985 Chaparral bow rider with a inboard 230 hp Mercruiser in it serial # A366565 I would like to change plugs and wires for this motor but not sure I have all the info for this motor was hoping someone could break it down for me...
I have a 199015hp force but I think my primer bulb stop working every time I open the gas cap on the tank or if the boat sits for a while I cant seem to start it with out adding gas to the carb. so I assume the primer bulb dont work does any one no were I can find one thanks for any help
I have a 1990 force 15Hp with a milky resadue coming from the lower unit it seams to be coming from I asume is were the is runs through the motor. as the motor sits it leaks from the holes.when I started it spits it all out thn leaks again.
My question is this a mayjor problem and what is...
Hello everyone I have a 1956 7.5 HP johnson and I was putting the head back on when I relized there was a hole in the core plug of the not sure if this hole belonges there or if I should replug it.
Now mind you all this motor was giving to me with the head off so I dont know how it ran or if...
I have a 1956 7.5 HP johnson I need the torque specs on the head bolts I think they call it head bolts the part i need to bolt back on is were the spark plugs screw into
Hi, all
just got a 1956 7.5 Hp johnson seahorse givin to me but they started to replace the head gasket and never finished it I need a diagram of this motor so I can make sure nothig is missing thanks mike
I cant seem to find a prop for my 1990 force 15hp number on prop i have 2 here 8 3/8 X 6 and the other is p715 can anyone guide me to the right place thanks
