Part number 21945915. Pulled unit (mounted outside transom) based on initial troubleshooting. Lots of rust, some water, etc. Direct connect 12v power to the trim motor is unresponsive. WIRING: The power feed is two heavy gauge wires (Blue and Green). I get power there when tilt...
Is there a circuit breaker on this Transom/Gimbel housing mounted trim unit? Relay's click, trim motor not running. No up, nor down movement. I have the normal rocker switch on throttle lever, and dealer-added transom switch. Both initiate relay clicks. I see two heavy gauge Green and...
Trim button on the end of the throttle arm very loose and operational sticking. Replacement looks to be a VP 3856844 which I found online. I found two screws on bottom of handle that allows me to remove the 'grip' of the throttle arm and then that looks to be maybe two pieces snapped...
Cleaning up a new-to-me boat ('07 4Winns H220). Took the two cushions off the back sundeck to replace mounting bolts and clean cushions and boat fiberglass underneath. Someone (re: idiot) has been into one, and didn't use stainless steel staples. (nor bolts). I was unable to remove 95% of...
I would like to cut the noise down in a very large hard-surface engine compartment. Good Access. My 1984 sea ray 197 of 32 years had lots of wood, carpet, upholstery, and true insultation that really kept the engine noise quiet. This Four Winns just has minimum noise absorption materials...
A New used boat (2007) after running a SeaRay OMC 800 stringer outdrive for 32 years. Bought from dealer. After 12 hours outdrive not acting right shifting. Drained oil and it's black as the night. Typically, my old OMC would have a little water past seals and be a tad milky - just...
I have a throttle question.
The Throttle will not hold 'at speed'. Example, set at 30 mph and very soon it has slowed down to 25 mph - even in calm water. You can't stand in the boat by the wheel at running speed without having to constantly go to the throttle to speed the boat back up...
I've got a base to a Bimini top has wiggled loose (screws pulled out of the white fiberglass). Due to typical boating and short trailing stress, I need to repair very solid. Cannot get to backside of screws to use a bolt. J-B Weld has been my go-to in non-boat projects. Recommendations...
Working on control switch and had been trimming engine with screwdriver between posts of solenoids to adjust engine for fuel and oil work. All of a sudden, trim quit. Got good power coming out of solenoid (both up and down). Worried about trim motor replacement hassle. BUT, noticed trim...
Trying to get boat in shape. Need two things. Bracket that holds fuel filter unit to block, and the first rubber boot coming of the exhaust riser. I can find the exhaust parts it looks like at a couple places, Where can I find a bracket?? Thanks!
