Recent content by usedcarman

  1. U

    weight of a Suzuki DF70TL

    Hi everyone, I've been trying to find out the weight of my outboard engine for a while and can't seem to find anything on the web. I own a 1999 Suzuki DF70TL 4 stroke tiller, I even asked a local dealer and he can't help me, Could someone point me in the right direction or provide a link where...
  2. U

    12 volts versus 24 volts

    Hi everyone, Last spring I purchased a Lund Angler 1700 with a 70hp Suzuki 4 stroke tiller, it didn't have a trolling motor on it, so I e-mailed Minnkota and asked what would be the adequate bow mount trolling motor for my boat, it weighs about 1300 lbs with engine, full tank of gas and all my...
  3. U

    1999 Suzuki DF70 tiller exhaust noise?

    Hi boaters, I own a 1999 Suzuki DF70 tiller four stroke pushing my 1700 Lund Angler. A couple of weeks ago it started making a muffled noise in low RPM's in forward gear. Nothing in neutral or reverse. It runs great seems to have normal power, always starts right up. But once in while specially...
  4. U

    suzuki DF70 prop selection

    Hi Folks, I just picked a used 1999 Lund Angler 1700, that weighs about 960lbs dry weight, and it has a 1999 Suzuki DF70 four stroke that weighs about 319lbs. Problem is there was no prop on the engine when i bought the unit, it had been damaged, engine runs fine nonetheless. But now i can't...
  5. U

    2002 Yamaha F100 4 stroke weak coil?

    Hi Folks, Bought this boat last fall, came with a 2002 Yamaha F100 4 stroke carburated engine, when i got it started this spring, it was misfiring on #4 and seemed to have very weak spark, seemed to be running on 2 or 3 cylinders, but specially bad on number 4. But it always starts up fine...
  6. U

    hooking up a kicker to main engine

    Hi again, Another question, what would you guys recommend to connect my kicker to the main engine, main is 100hp Yamaha four stroke, approx. 24" center distance to T8 Yamaha kicker that i just picked up, now there's a few companies that make a steering bar for that. I looked at EZ steer online...
  7. U

    Yamaha T8ELRB

    Hi Folks, Looking to purchase a kicker motor for my Lund Prosport 1675, and there's one available online from a fellow about 8 hrs drive from me, it's a 2003 Yamaha T8ELRB with all the remote controls and stuff. I've asked the seller what lenght of shaft it is, but he doesn't know! And I've...
  8. U

    2000 Lund 1700 Bob Izumi Adventure specs

    Hi eveyone, I"m looking at a 2000 Lund Bob Izumi 17000 Adventure for sale on the web, can someone direct me to a website that could give me the specs on that unit, I've tried just about everywhere and can't find anything on it. It's powered by a 2000 Evinrude 115hp and a 9.9 kicker. It looks to...
  9. U

    Looking to buy Lund 2025 and Merc 125HP Saltwater (good match?)

    Hi everyone, I'm new at this, so bear with me if you can. I'm presently looking at purchasing a 2001 Lund 2025 Pro V with a Merc tiller 125 hp saltwater pushing it. I know absolutely nothing of these saltwater engines, I fish the St-Lawrence river only. I'm wondering if this is the right engine...
  10. U

    1970 4hp evinrude lightwin impeller replace

    Hi Folks, Does anyone know how to get to the water pump on a 1970 4hp lightwin evinrude, it's got no tranny, you start it, it goes, no reverse, just turn the engine around. I got the 4 bolts out of the foot, was able to lower it about 3/8 inch and that's it, looks like something is locking it...
  11. U

    where to get 2 part foam filler?

    Hi Guys, First of all, I'm a newbie, new @ this site. Recently purchased a 1990 Invader 15'6" fiberglass bow rider with a 100HP merc, I knew that the floor was a little soft. Thought it would be just a small job to replace the floor. Upon removal I noticed that the crossmembers and ribs were...
See more
Top