Search results

  1. B

    E2OCRC05 lower unit removal

    I disconnected the piece behind the window of the LUnit and it will drop down about 8-10" but won't come all the way out. Moving the shift lever still moves the unit up and down like it is still connected. What am I doing wrong? Its about an '85 Evinrude 20hp with pull start. Thanks.
  2. B

    Old 15hp fleetwind knocks

    Evinrude superfast twin 15hp 15012-47097 This motor is new to me. I cleaned the carburetor and went from 30 sae to 24:1 two cycle oil. It is hard to start and it ran about 1 minute after putting the carb back on. It was knocking until the low speed needle was leaned out. After 10 seconds it...
  3. B

    need part #'s for '62 40hp johnson starter bracket and starter

    Can anyone tell me what the part numbers are? Thanks. Johnson RDSL-24 M
  4. B

    What would cause a Johnson 9.9 to run rich?

    I'm convinced the reason the motor won't get full power is because it is running to rich. The motor is a '92 J10rena. The carb had a kit put in and the plastic cover has been replaced with the upgrade. The float is adjusted as per manual. The only thing I can think of would be the needle/seat is...
  5. B

    E8RCOB Evinrude 8 hp cam adjustment

    The motor is a 1985 Evinrude E8RCOB and the cam needs to be checked for the correct adjustment. There is a star screw on the left side and one on the white roller. How is it adjusted? I do know the throttle plate usually starts to move when the index is in line with the roller and should be...
  6. B

    How do I check for voltage at key switch on M50D Tohastu? Schematic?

    3E3 5059 M50D about 1992 The engine won't turn over. The neutral switch in the control box works ok. I can jump the starter and the motor runs ok. A new key switch didn't help. Are the male red and female green wires at the control box where the 12volts come through? If I want to bypass the...
  7. B

    Tohatsu M50D ignition switch test

    The 1990 switch has 6 wires with 2 red ones. The test procedure only calls for testing one red one, so I did both. It only passed one out of 2 tests. I was wondering why the 2nd wire wasn't mentioned> Thanks.
  8. B

    What to use or where to get lower gear case seal?

    There is a seal in the old blue Evinrudes tht looks like screen spline and the old number is 302604. What can I use for this purpose and they also talk about Marprox sealer 1000. What kind of sealer is it? Thanks.
  9. B

    Flying bridge cover ID and value?

    This top has a clear windshield in the front and a screen that rolls down the back. It is 67" wide connects by one leg on each side and forks to the top. I would like to know what kind of boat it works on, what they sell for, or where to look for a price.> I put it on the car. The right picture...
  10. B

    Does rpm limiter on power pack shut a cylinder down?

    The PP #585260 is on a J48ESLEDC1996 and sometimes both cylinders are firing and sometimes not. The carbs are ok so would it be safe to say it was a PP or would a stator or wiring harness have something to do with it? Pr is a DVA the only way to find out? Thanks.
  11. B

    2 stroke oil blockage in head or exhaust?

    We have checked and rechecked everything on this 9.9 J10 Rena and it still won't accelerate but idles perfectly. It had a bad fuel pump and oil sludge running out of the top and bottom exhausts. It sat for maybe a year or 2 like that. I took the exhaust cover off and cleaned out the goo in the...
  12. B

    J10rena idles great but possibly floods out one cylinder. Why?

    How would the late carb with the plastic top flood out a cylinder? Thank you.
  13. B

    Does a 1996 48 have a power limiter?

    It won't power up and has a 585260 Power Pack. Does it have a limiter or can a PP go partially bad? Thanks.
  14. B

    '92 9.9 power pack have a power limiter?

    Still can't get this J10rena to power up. It has a power pack / ignition module #583667 under the flywheel. Is there a power limiter in it that might be stuck? It idles great and even sounds good revved up with ears on it, but when on a boat in the water, no power. My mechanic is checking it out...
  15. B

    Minnkota AP 65# riptide motor won't go in forward

    My neighbor brought it over and I am not familiar with how to switch from forward to reverst. It goes left or right and in reverse, but nothing works for forward. What might be wrong with it? Thanks.
  16. B

    Johnson 48 speed limiter and harness

    This 1996 won't power up and someone told me it might have a power limiter when there is an electrical problem. He said to check the wiring harness first and than the power pack. Tha battery to switch wire was bad so can anyone tell which wire or wires have anyth ing to with the limiter? Thank you.
  17. B

    Too much pressure pulling bearing case on 35hp?

    Is it possible to damage something if puller is tightened too much? I made hooks out of 3/8" eyebolts. Transmission fluid, rust buster and other stuff has been put on the bearing case and heated with a small propane torch. I should have just replaced the seals instead of heating but didn't know...
  18. B

    Time 48hp at idle?

    This is a '96 model. There is nothing wrong with the carburetors yet it won't go much above idle. An '86 manual says to check the timing at about 19 degrees at full throttle in the water. At idle the chalk mark is about 1 to 1 1/2 inches off the mark if that proves anything. Can the timing be...
  19. B

    Oil on top of 9.9 driveshaft

    Re: Oil on top of 9.9 driveshaft I've been messing with this motor off and on for quite awhile. I saw the bill of sale from the guy I bought it from. He bought it new and used it about 3x as a kicker motor and it sat in the Florida sun all these years. It worked ok for 20hrs than wouldn't...
  20. B

    Oil on top of 9.9 driveshaft

    This is a J10Rena 9.9 2-cycle and the top 4 inches of driveshaft is coated in oil and running down the shaft. It is also on the outside of the midsection. Is the lower crankcase seal bad or just running to rich? It doesn't smell like gear oil. Thanks.
Top