Search results

  1. M

    EVINRUDE 1965 90 HP STARFLITE no spark

    Awoke a sleeping Starflite,was sitting for over 20 years,has good compression but cant get no spark. Got 12 volts going into the coil,checked output of coil with key on(Not cranking) with test light got nothing but got 11.5 volts with volt meter. Does anyone know the steps to go through? I...
  2. M

    EVINRUDE 1965 90 HP STARFLITE spark test

    Trying to do a spark test and have no key. Going to use a remote start switch jumping the solenoid.. would I still get spark with the ignition in the off position? Any help would be great. Thanks Mike
  3. M

    Parts for 1965 Starflite 90 evinrude

    Boat sat for 30 years and is not locked up,only had 15 hours on it before it was garage kept. Anyone know where I can get parts for this engine? And what I need to replace Carb kit,ect,ect Thanks Mike
  4. M

    Johnson moter sat over 30 years in garage

    Only 15 hours on Motor Has not been started in over 30 years,been in a Garage all the time. 60s model 50 hp 2 stroke Whats the best steps to take . OIl cylinders,.... take drive off before trying to move flywheel? Thanks Mike
  5. M

    Yamaha GP1200R tell if motor locked up

    My Machine stopped ,when I try to start it,it just clicks ( Batt is good) Took the plug out of the cylinder towards the back and it was mashed in. Any thoughts on what happend? IS there a way to see if the motor is locked up ( cant see a way to get to the Flywheel) Any advise what to do...
  6. M

    2005 Evinrude 75 E-TEC low compression

    My Friends case... Ran fine was sitting for about a year,Changed fuel in tank...when I went to start it would start but then choke itself out. It will run but it don't want to Idle. And when you put it in gear it will die. Compression on number 3 cylinder is at 80 and the rest are at 110. Can...
  7. M

    Fuel vaccume check

    I have a 1989 Evinrude 88hp SPL,bought a vaccume gauge. Does anyone know what the specs should be for checking for leaks in the fuel lines? Thanks Mike
  8. M

    1989 EVINRUDE 88 SPL torque specs

    Does anyone know where I can get a Factory Manual for this Motor? 1989 EVINRUDE 88 SPL (either book or cd) Needing the amount of torque and head bolt patterns. Thanks Mike
  9. M

    Need 1989 Evinrude 88hp SPL head gasket

    I have a 1989 Evinrude 88hp SPL ,need head gaskets for it. Does anyone know the best place to buy them from? Thanks Mike
  10. M

    Need lower drive special tool to remove seals

    I have a 1974 Johnson 50hp outboard that needs new lower drive seals installed. Does anyone know where I can get this tool? Thanks Mike
  11. M

    Hp and year from serial number

    Does anyone know how to decode the year and hp from this serial number? Or where to find the info? 6502m-e10796 Its a evenrude,looks like a 9.9 Thanks Mike
  12. M

    Marine tools

    Does anyone know a good place to buy special marine tools at? Like drive tools,ect Really looking for a outdrive presse tester. Thanks Mike
  13. M

    Leaking oil bad from prop

    Is this normal,? This is a johnson 2 stroke 50 hp 74 model. Any help would be great. Thank you Mike
View older results
Top