Search results

  1. J

    Is it worth to buy part's?1972 25 hp. evinrude

    Hey guy's i just removed my head gasket to replace the gasket and I found this on the wall. this is the top cylinder and it read's 90 comp.and the bottom is 110. I removed the manifold gasket as well and the gasket has never been changed and it was very difficult to take the gasket. Is caked...
  2. J

    hair line crack

    Hi there is this something to worry about or can it be fixable let's say epoxy? http://i111.photobucket.com/albums/n144/jethro66/piceof****010-1.jpg
  3. J

    Little help please 1972 25hp evinrude

    Hey guy's,how do I properly install The shift yoke and cradle on the drive shaft? The illistration's on my online manual is a little to hard to see. thankyou
  4. J

    Just wondering

    Hey guy's Quick question can a 1955 25hp johnson RD17 lower unit fit on a 1972 25hp Evinrude 25203r? Or can I get new or used part's for it ? Eg. Frd gear, clutch dog, cradle, shift rod
  5. J

    Old gas

    Wat do you do with old gas? I have 2 and a half gallons in my outboard tank and i forgot to but stabilizer's in it?Is there a place to properly dispose of it? it's about 4 month's old with 50:1 mix in it . thanx
  6. J

    sail outboards

    Hey guys wats up,I was on ebay today and i saw these outboards called Sail. Has anyone else seen these before? Are they any good they have good deals!!
  7. J

    parts

    Hey guys wats up I wanted to know were I can find a shift yoke and cradle for my 72 25hp johnson. its shot and i cant seem to find one any ideas? Thanx!
  8. J

    2006 18 hp tohatsu

    Hey guys wats up , Im really interested in the new 18 hp tohatsu how do they stack up against merc , johson and are they 2 or 4 stroke thanx!
  9. J

    7225hp evinrude wont start

    Hey guys wats up I put in a carb kit and a tune up kit on my motor with a oem manual and now she wont start .what should i check before I take it in? do i need to put that little spring on the needle , i lost it1 I got the right parts help!!
  10. J

    testing coils

    hey guys wats up can you test the coils yourself? I used a volt meter and i got a reading on both of my coils and i dont see any cracks etc but the points are a little dirty and there gaped propelry the wires are a bit gresase as well any ideas ?
  11. J

    fin to low

    hey guys wats up how can you repair the botom fin orget a new par for it
  12. J

    fin to low

    hey guys wats up how can you repair the botom fin orget a new par for it
  13. J

    Drive pin 1972 25 hp evinrude

    Hey guys wats up, I tested my motor in the tank and noticed my motor does not shift in gear. shut it off and noticed my drivepin broke in the tank. i replaced it before but I fabricated it . the dealer told me he did not have one so grind it down. I noticed that when I twist the tiller theres...
  14. J

    1972 25hp Coils

    Hey there wats up I put in my new plugs (J4C) and it statrs I pull the top plu and it runs the same. Put it back in start her up and pull the bottom plug. stops Do i need a new ig. coil? Replace the wires as well Do i need a balance puller to take the fly wheel off? Please help!!
  15. J

    oily plugs 1972 25hp evinrude

    If the plugs are oily and wet do i have carb isuses? they arare jc8 and supposed to be JC4 please help!!
  16. J

    lowend

    Hi there just wondering how U take the low end unit off there was a libit of water coming out a i F__-- up one of the bolts (the head broke) please help
  17. J

    plugs

    hey i was looking at a different thread and it says I need J4c spark plugs on my motor there J8c does this eefect performence? its a 1972 25hp evinrude
  18. J

    stumped 1972 25hp evinrude

    Hey guys wats up. I put in a carb kit and a pin and it still bogs ! Wat can it be ? Impeller ? coils, plugs wires ? it starts aon second pull. Timing? I give up should I take it in my manual is gona be a while
  19. J

    prop

    hey guys wats up? I have a 1972 25 hp evinrude and i was wondering if i could still buy a new prop? I think it broke today .when its in gear i can turn the prop by hand and i could see were its connected with the pin its spinning .wat a money pit !! any sugestions??
  20. J

    1972 25 hp evinrude 2520

    hey guys wats up? I took my motor out on the lake today to test out the motor. It starts on second pull but when I take off its bogging like something is holding it back. I open the cowl and I see on top of the fuel pump seperate from the fuel pump theres a hose that is cut off I lok beside the...
Top