Search results

  1. W

    99 merc 150 efi cutting out and dying at full throttle

    A friend of mine has a merc 150 that seems like it is not getting fuel. He will be cruising along at WOT and it will just quit. When you go back to the motor the fuel bulb is not pumped up. When you pump it back up it will be fine for another hour or two, then the same thing happends. Any...
  2. W

    where to find V6 emblem on back of cowling?

    Does anyone know where to find an emblem for the rear of the cowling on an 88 Evinrude 150 XP motor. I have been keeping an eye on ebay, but havn't seen one in the past few months. Thanks in advance for your help.<br /><br />Steve
  3. W

    gear ratio for a 1991 40hp evinrude?

    Does anyone know the gear ratio for this motor, it is a short shaft tiller if that makes any difference. thanks for the help<br /><br />Steve
  4. W

    1979 johnson 175 hp, where is the tilt/ trim sender?

    I was wondering where to hook a gauge up to, but i don't know if there is a sender/where the sender is or what wires to hook up to. Thanks for the help and sorry for the stupid question.<br /><br />steve
  5. W

    rectifier on 2.5L sea drive?

    Hello, i have a 1985 2.5L Sea Drive powerhead that my mechanic says needs a new recifier. Sorry for the stupid question and all, but what exactly does a rectifier do and about how much should it be to replace this part. Thank you for any help you can give. Steve
  6. W

    tach selector switch

    the motor on my boat was switched to a 1985 evinrude 175 from a 90 merc 200. The tach is doing all kinds of strange things and i'm not sure why. My local repair shop said to check and make sure the selector switch on the tach was on position 6. When i looked at the tach, the selector swith...
  7. W

    tach goes backwards?

    I bought a boat last season and have a tach that will work fine some of the time, but will somtimes sit on 1k at idle and when you open up the throttle the tach goes backwards and hits the pin at 0 rpms. Then when you slow down the needle will go back to 1k. Does anyone know why this might...
  8. W

    please help me identify year and Hp

    I received this motor from a friend and i have no idea what it is. He said that it does not have the original powerhead on it. All i know is that it is a V6 OMC. The serial numbers on the freeze plug on the block are:<br /><br />ICCXCOM<br />J086320<br /><br />It is really hard to find any...
View older results
Top