Search results

  1. J

    Alpha one drive gear /shaft od 1.50:1

  2. J

    Alpha one drive gear /shaft od 1.50:1

    So you use the small spacer with the press fit setup and have had no problems? The old spacers are thicker than the new is there any Benefit thicker vs thinner spacers?
  3. J

    Alpha one drive gear /shaft od 1.50:1

    Ok. I have gm 230hp and 1:50:1 ratio. It seems the 1.50:1 has the same step on shaft. I have the correct bearings now. Thank You
  4. J

    Alpha one drive gear /shaft od 1.50:1

    Yes I realize the input shaft should use that same size bearings. I ordered bearings for the 1.50:1 heavy. Apparently I have 1.50:1 non heavy. I’ve got correct bearings now through local shop. On the press fit shaft I thought you’re not supposed to use inner spacer?
  5. J

    Alpha one drive gear /shaft od 1.50:1

    I have a alpha one I’m trying to replace the bearings in the upper on the drive gear u-joint shaft. My serial no is 0b496372 there is an f stamped by the serial no. That should make it 1.50:1. I even counted teeth drive gear 22 driven gear 20. Looked up part number for bearings for 1.50:1 ratio...
  6. J

    Replacement or Rebuild for Alpha One Power Steering Ram

    Where did you find the QDs for new actuator. I can only find oem hoses with QDs.
  7. J

    Alpha one gimbal ring bearing replacement

    Yep a zerk a passage and a hole in the side of bearing.
  8. J

    Alpha one gimbal ring bearing replacement

    Didn’t seem to bottom out. Grease hole aligned. I have a roller bearing didn’t see a sealed option.
  9. J

    Alpha one gimbal ring bearing replacement

    The seal and spacer are installed in the picture
  10. J

    Alpha one gimbal ring bearing replacement

    Alpha one gen 1
  11. J

    Alpha one gimbal ring bearing replacement

  12. J

    Alpha one gimbal ring bearing replacement

    I’m replacing the bearing in my gimbal ring. I’ve got it pressed in but not sure how far to go there is a seal and spacer that go on bottom. I don’t know it the spacer is supposed to set flush with the bottom or what?
Top