Search results

  1. Faztbullet

    2019 Lower Unit Paint Chipping

    Yes it happens a lot on tri-toons
  2. Faztbullet

    2019 Lower Unit Paint Chipping

    See other site as cavitation burn
  3. Faztbullet

    No blocking diode in slow mode VE115TLETS wiring harness????

    All repairs start with basic troubleshooting. A 2 stoke engine must have 3 things to run. 1) Spark energy at plug to fire fuel charge under compression 2) Satisfactory compression to support combustion, a compression test will not tell you condition of cylinder! If its 10psi lower than others...
  4. Faztbullet

    Will a 1976 85 hp head fit my 1969 85 hp?

    As long as its a small bore 85 it should fit
  5. Faztbullet

    Intro and question

    Looks Bubba rigged with OEM bracket as original starter was a field/frame style motor
  6. Faztbullet

    1994 Johnson 150 HP

    A weak impeller will cause rect/reg failures due to it overheating at slow speeds. Water does not fully fill the block cavity to reach heat sink fins. Rectifier is then damaged internally then fails.
  7. Faztbullet

    68 evinrude 85hp msd conversion

    Better off using a old automotive amp(Mopar) and coil to keep from burning up rotor
  8. Faztbullet

    Will a 1976 85 hp head fit my 1969 85 hp?

    Whats wrong with your head?
  9. Faztbullet

    Intro and question

    If it has label not to hit with hammer thats a magnet frame stater. Either its NOT a 1974 or someone has bubba rigged.
  10. Faztbullet

    1986 Mercury 90 hp 6 cylinder only running on #2, 4 and 6 cylinders

    If even cylinders are still firing after wiring swap replace switchboxes as a pair
  11. Faztbullet

    Intro and question

    That starter has been NLA for a long time and no aftermarkets
  12. Faztbullet

    1986 Mercury 90 hp 6 cylinder only running on #2, 4 and 6 cylinders

    Is 1,3,5 sparking?
  13. Faztbullet

    No blocking diode in slow mode VE115TLETS wiring harness????

    Forget the SLOW feature as motor never had it. This is causing you to run down rabbit holes. #2 compression is suspect
  14. Faztbullet

    system check tach question

    Install a standard tach
  15. Faztbullet

    Clutch dog

    Does it have the original 2 dog clutch or the upgraded 3 dog?
  16. Faztbullet

    2001 200hp Carburetor Torque Specs

    From the Factory Manual... calibration pocket gasket...10-15 in lbs side cover...24-30 in lbs high speed jet....30-35 in lbs float chamber...18-24 in lbs Send me PM and will send you the pic as site will not allow post for somereason
  17. Faztbullet

    1999 Mercury 50hp Hub kit: HELP

    Looks like posted BS as the part # for prop you posted is a pressed in hub and does not use a hub kit. Uses press in hub like below.. https://hmshubs.com/products/
  18. Faztbullet

    1994 Johnson 150 HP

    Dont replace it till 100% of the dry chemical is gone from engine
  19. Faztbullet

    2005 115hp 4 stroke EFI - Flames coming out of Intake

    Timing off?
  20. Faztbullet

    1986 Mercury 90 hp 6 cylinder only running on #2, 4 and 6 cylinders

    Just exchange the red/blue wires to opposite switchbox's. If 2,4,6 starts firing and 1,3,5 stops its the stator. If problem stays replace BOTH switchboxes with omly OEM, Serria,EMP or CDI/Rapair
Top