Search results

  1. Faztbullet

    93 evinrude 25 hp primer

    Need to adjust it in a barrel or backed down in the water....
  2. Faztbullet

    93 evinrude 25 hp primer

    On hose or in barrel??....Gotta have backpressure
  3. Faztbullet

    Assembly question

    Assemble on crank and drop in as cylinder top is tapered....
  4. Faztbullet

    1995 Evinrude 50 hp

    If it's a 2-cylinder 50HP the shake is normal
  5. Faztbullet

    Driveshaft question

    Wont know till ya pull powerhead..If a brackish or salt motor could be sping gave way
  6. Faztbullet

    Driveshaft question

    That is the spring for the lower crankcase seal on powerhead. Need to pull powerhead and replace seal
  7. Faztbullet

    gas in oil

    Check fuel pump for leak
  8. Faztbullet

    1978 Mercury 90hp outboard

    Rings do not stick in a outboard unless submerged, especially a single cylinder on a multi cylinder motor. Pull the transfer cover and inspect piston. Also mount the starter correctly/
  9. Faztbullet

    50HP evintude tiller fuel connector question

    Yea right....rates right up there with the Autoblend units reliability.
  10. Faztbullet

    Boat and motor given to me

    VRO = Very Risky Oiling in the late 80's
  11. Faztbullet

    Boat and motor given to me

    1) Find and reinstall tiller arm 2) Check compression and ignition for spark 3) If OK ...clean and drain fuel system and rebuild carbs 3) If VRO/OMS is still in service drain and flush oil tank and lines, then verify its working 4) Install a new impeller
  12. Faztbullet

    mercury 25hp 4 stroke water tube clogged

    Unless you block off the intake under the cavation plate, it wont pick up on a hose. Will work fine in a bucket...
  13. Faztbullet

    O-ring on Vernatherm - 70HP, 2000 Johnson 3 cyl

    Not OEM
  14. Faztbullet

    Melted wires/2001 Mercury 60/40 Jet

    Common problem with these rec/regulators...test rec/reg and replace if need be and repair wiring.
  15. Faztbullet

    1986 35Hp Mercury no fire

    No switchbox/pack test
  16. Faztbullet

    Lower unit

    No leak..just exhaust escaping thru mating seam...100% normal
  17. Faztbullet

    Does this indicate water in lower unit oil?

    If standard Auto 80/90w was installed it will turn "baby poop yellow" due to foaming.
  18. Faztbullet

    1986 35Hp Mercury no fire

    Not coils but switchbox/pack...
  19. Faztbullet

    1986 35Hp Mercury no fire

    Looks like pack bad as specs are really close.
  20. Faztbullet

    Installing lanyard kill switch on 1971 Merc 7.5 HP with thunderbolt phase maker ignition

    Get the kill tether with the 4 poles ...2 that are NO and 2 that are NC. Just splice it inline on the salmon wire before OEM kill button, attach to the NC terminals on new kill tether. This will break the ground from stator.
Top