Search results

  1. K

    timing advance

    i just switched over to electronic ignition and set the timing. the specs call for 6 degree btdc but i found the engine didn't idle smooth at that and seemed to like 10 degree advance better. any harm in leaving it at 10? will this cause detonation? i had her out yesterday and she didn't seem...
  2. K

    bad coil?

    i read the the sticky on top about trouble shooting a no spark situation and according to that i have a bad coil. i have continuity between the small pos and neg but nothing between the larger center plug in and either the pos or neg. that means bad coil? also i was wondering why this coil thats...
  3. K

    merc 165 no spark

    hi, hoping for some ideas here, my boat was working fine last fall but i tried to start her up last week first time since last year and she won't start. turns over great, getting fuel but don't seem to have any spark on the plugs that i can see when i remove one and turn her over. there is 12...
  4. K

    running hot on hose

    I've noticed lately that my engine runs hot on muffs with the hose, about 180 degrees, but ok in water, about 140 degrees. Seemed like this started this summer one time when i noticed her getting hot on the hose and saw there wasn't much water coming out of the exhaust, then she made a big spurt...
  5. K

    ocean swell

    i was wondering if an 8 foot swell coming from 2 opposite directions could create dangerous conditions where they meet? seems like thats the situation here today and i was thinking about going fishing, only 2 days left in the season.
  6. K

    engine fogging

    well its that time of year and i'm wondering about fogging the engine. i usually remove the plugs and spray oil into the cylinders but i've heard that you can just spray the oil into the air intake while the engine is running? whats best and how much oil would you spray into the intake? until...
  7. K

    almost lost new reel !

    Was cod fishing today with a new Penn reel i bought. Saw some large fish that i think were tuna come up and take some small fish we threw back. About 15 minutes later i hooked a nice fish and was reeling him in when the line just stopped and then began stripping out off the reel, it nearly...
  8. K

    pre alpha lower unit

    i think the gears in my lower unit are shot, she skips in reverse badly now and even sometimes in forward, also often cuts out when i engage in forward. anyway the drive is a 1978 pre alpha . i think its a MR but not sure. i have ordered a old pre alpha lower unit on ebay from a different motor...
  9. K

    sea ice

    lots of pack ice moving down my area this past week. looks really cool but can be deadly. take a look: http://www.cbc.ca/news/canada/newfoundland-labrador/natural-mortality-cooks-cove-whale-1.4052889 http://vocm.com/news/residents-warned-to-stay-off-pack-ice/
  10. K

    lucky escape

    local fishing crew had a close call this weekend...... http://vocm.com/news/like-the-perfect-storm-but-with-a-better-ending-fishermen-rescued-from-raging-seas/
  11. K

    new F150

    My old ford f150 just rolled over 300000 km. She is a 2001 and getting a little rusty on the rocker panel under the door. I was thinking of getting a second hand 2015 f150 when they start to hit the market in a year or two. I want the aluminum body so I won't have rust problems. Here where I...
  12. K

    Safety chains

    On my way home from rabbit hunting today I passed a group of guys on the side of the road, with a trailer they were hauling back to their truck. They had an ATV on the side of the road with the wheels hanging off presumably having once been on the trailer. I don't know if safety chains would...
  13. K

    lawnmower surging

    Just finished mowing the lawn for (I hope) the last time this year. the lawn mower was constantly revving up and down. What would cause this? Some kind of carb problem I assume. Its a briggs and straton 3.5 hp push mower (I think)
  14. K

    question about s/s prop

    I hear lots of people stating how they get better performance with a stainless steel prop and I don't dispute it. I'm just curious why this should be? If an aluminum prop and a s/s prop have the same dimensions why would one preform differently? Is it because s/s is stronger and don't flex?
  15. K

    kicker size

    I'm not sure if this is the right place for this question but I was wondering about kicker motors. Specifically i'm wondering what size hp I would need for a kicker on a 19.5 fiberglass boat with an I/O motor and drive? The boat weighs about 2500 lbs i'm told. I want something as a backup to get...
  16. K

    Impellor question

    Can water hang up in the impellor housing between the vanes and freeze or does it all drain out when the leg is down?
  17. K

    Always be careful of slippery slipways!

    Just read an article on the local news site about what happened to some poor guy on the very last day of the fishing season this year. Good reminder to always be ware of algae build up on the ramp, esp. at low tide in salt water! have a look...
  18. K

    Voltage question

    Hi, while winterizing my boat today I noticed that the voltage showing on the gauge was only 12. Its usually well over 13. Using a volt meter I checked the pos and neg at the altenator and it was in the 15ish range, checked at the battery and got over 13, then checked at one of the solenoids...
  19. K

    Manifold Riser

    Hi, I was getting my boat ready for winter today and for the first time ever I drained the riser by removing the brass screw. A small amount of water came out, maybe quarter to a half a cup. I never drained it any other year because I figure that since its essentially an upside down "u" and I...
  20. K

    mold for lead cod jigger

    Hi, does anyone know where I could order a mold to make an old fashioned lead cod jigger? I have a mold for making a 5 oz small baitfish jigger but the kind used here in newfoundland years ago were twice as big and used one or two large hooks imbedded in the lead instead of a treble hook that's...
Top