Search results

  1. N

    1999 bayliner vibration

    motor is in, front mounts where the belong, alignment tool slides in with one finger and spins great, messed up the shift points though.
  2. N

    1999 bayliner vibration

    wood is all good, 3M 4000 it is thanks.
  3. N

    1999 bayliner vibration

    i do have an alignment bar, thanks or tip, do you know what kind of calk to put on mount holes?
  4. N

    1999 bayliner vibration

    i removed the bellows and put the old shaft trough bearing, found gap starboard side and a little towards the top. tried moving frt of engine to port side but not enough adjustment, removed the lags a pushed engine over 1/2 inch and that shaft slid in easy. lifted engine found double holes for...
  5. N

    1999 bayliner vibration

    did not spin, just searching for other alignment causes
  6. N

    1999 bayliner vibration

    when gimbal bearing got hot could it have damaged the housing and not be visible?
  7. N

    1999 bayliner vibration

    going to work on it in a little while, will post pics then, fibers appear to be glued.
  8. N

    1999 bayliner vibration

    can i shim rear mounts?
  9. N

    1999 bayliner vibration

    rear mounts are sierra 18-2193
  10. N

    1999 bayliner vibration

    engine still out of alignment, new rear mount, front mount had already been replaced, new gimbal bearing, installed with new bearing tool. front of engine will not go low enough. original bearing failed to the point shaft had to replaced.
  11. N

    1999 bayliner vibration

    I WILL CHECK THE TRANSOM
  12. N

    1999 bayliner vibration

    thanks for all the advise everyone, will let you know what happens. i think it is in the rear mounts, replacing coupler because i am there
  13. N

    1999 bayliner vibration

    bushing drive had a lip on it, port side rear mount bolt is at a angle, all parts are there but looks cooked. when you first install aligning tool it kicks a little to left to start and goes in tight. up and down makes no difference. going to install new mounts, coupler, and gimbal tomorrow.
  14. N

    1999 bayliner vibration

    bearing is seated, used bushing driver to seat, port side mount the bolt looks to be going in at a angle.
  15. N

    1999 bayliner vibration

    new prop, just checked alignment, it is off can not tip engine enough for tool to slide easy. previous own had engine out to replace a mount, then he burnt up gimbal bearing. then i bought it, new joints new shaft new gimbal, ran smooth for about hour, started vibration. have slight scoring on...
  16. N

    1999 bayliner vibration

    I have a 1999 bayliner 4.3 alp1 gen 2, vibrates turning left and right and trimming up or down, has new u-joint, shaft and gimbal bearing, need some ideas.
  17. N

    1999 bayliner 2052ls vibrates turning, and triming up and down

    1999 bayliner 2052ls vibrates turning, and triming up and down
Top