Search results

  1. J

    Ford 302 issues

    I was hunting wires and following my manual. It shows white from harness to electric choke...my white wire went to coil negative. Not sure why
  2. J

    Ford 302 issues

    I haven't got a tester so I will take it and have it tested. I followed a vidio on how to test with voltmeter and it shows up good
  3. J

    Ford 302 issues

    What should it be with electronic
  4. J

    Ford 302 issues

    I've got pertronix ignition. The only gauge that is high is ammeter. It doesn't do it if I'm idling along when I get on the throttle it starts. Feels like it's running out of gas kinda. Chug chug chug and dead if that makes any sense
  5. J

    Ford 302 issues

    Also add this...only happens under load..not on muffs
  6. J

    Ford 302 issues

    Good day I have cleaned and replaced any suspicious wiring and went out yesterday. Boat ran great. Fished for few hours at anchor and when I went to move the boat started cutting out and stalled. Rest of the day same thing. The gauges are not doing what they were aside from ammeter..running...
  7. J

    Perco battery switch install

    Is there a preference on what to use
  8. J

    Perco battery switch install

    Now should I install a bus bar for all my grounds. Seems it would tidy up my wiring
  9. J

    Perco battery switch install

    I've got her figured..all working now. Thank you
  10. J

    Perco battery switch install

    Morning, ya shoot I was talking slave you are right. It's a ford 302, boat is a 1975. One wire is on the positive and one wire is from main harness on the 50 amp.
  11. J

    Need Help With Knowledge Around Replacing a Fuel Pump

    I would pull the bolt out that goes into the valve cover and undo at carb..should come free I believe
  12. J

    Perco battery switch install

    I figured it out...however now I have no dash lights or blower lol...nightmare
  13. J

    Perco battery switch install

    Picture one is...bat 1 to post 1 on switch. Bat 2..on bat..2 on switch...common has one directly to starter and 1 cable to left side of solinoid...when I turn it to bat 1 it cranks over..with out key. What in the heck have I done wrong
  14. J

    Perco battery switch install

    Ahhh. Thank you
  15. J

    Perco battery switch install

    Still not grasping were the 12v positive from battery to soliniod goes. From common to positive on soliniod?
  16. J

    Perco battery switch install

    Nothing I have read says anything about it
  17. J

    Perco battery switch install

    Does the switch go before the starter soliniod or after...not sure
  18. J

    Perco battery switch install

    Down riggers and fish finder off house battery?
  19. J

    Perco battery switch install

    Ok thanks
  20. J

    Perco battery switch install

    Trim pump..anchor winch..blower. bilge pump
Top