Search results

  1. alldodge

    Winterize My 2009 Tahoe Q5i 4.3 V6

    Depends what cooling system you have and if it's 7 point, 3 point or single point drain. In any case drain all the water from the block, exhaust, fuel cooler, raw water pump if Bravo drive and front large hose. Once that's done your winterized. You can now pump AF with muffs if you wish or pour...
  2. alldodge

    Volvo Penta 3.0 Beeping and Ggoing Into Limp Mode

    Manuals can be obtained from a VP dealer The ECM is quite expensive and really need to make sure it's what is causing the issue. I'm guessing but sounds like your between a rock and hard spot because there are no VP dealers near you. It's easy enough to replace the ECM part number is 21367572...
  3. alldodge

    2002 Four Winns 240 instrument problems

    The sender is on the drive, and most likely same as Merc needs replaced The depth sounders seem to always change and next to none of them work with other manufactures, then you have the issue that replacements are no longer made. In most cases just need to get another
  4. alldodge

    Does the antifreeze you use really matter?

    Your motor is safe because you drained everything, but running 4-5 gallons thru engine pump does not displace ALL the water
  5. alldodge

    Does the antifreeze you use really matter?

    This is there so folks won't put it in a cars radiator or boats with heat exchangers. And BTW, don't post in FAQ area
  6. alldodge

    Trolling Motor and Deckhand Anchor

    Welcome You can use same batteries to power both windlass and trolling motor so long as the voltage matches the unit Exp: can have a 36V trolling and 12 or 24V windlass but tap off Bats equal to windlass requirements
  7. alldodge

    Bravo 3 Refresh Questions

    That's normal for a B3, it has 3 gears messing down there and not smooth like the B1
  8. alldodge

    2002 Four Winns 240 instrument problems

    When asking a question it's always best to let folks know just what your talking about. What motor and what depth gauge It's normal for time to cause trim gauge to stop working on all boats. In most cases it's the puck on the starboard gimbal ring. As for the depth finder, most likely same thing
  9. alldodge

    1996 5.7LX EFI TBI Timing procedure

    Scratch the previous, I was hung up on EST There are 2 ways to put motor in base timing mode. Do it with your scanner or place a jumper in the DLC connector. In base timing mode adjust rpm to 1200 if ECM doesn't automatically change. Set timing, return to idle and remove jumper or use scanner to
  10. alldodge

    1996 5.7LX EFI TBI Timing procedure

    Scratch that you side TBI
  11. alldodge

    Outside lower unit will not go up

    Good then you should have 2 relays and your wiring should be as in pic
  12. alldodge

    1st Boat

    Welcome If boat hulls are solid, then it comes down to which motor is in best shape
  13. alldodge

    tilt/trim

    You replaced the puck on starboard side and with wires connected it does not work. Connecting gauge direct to puck it does work There is a bad connection somewhere or your install method has an issue. I connect wires to puck, turn key ON, go back to puck and slowly rotate it until I get a...
  14. alldodge

    tilt/trim

    Sounds like there is a bad connection. The Brn/Wht goes thru the 10 pin engine harness. You could run a jumper from the puck to the gauge to verify there is a bad connection
  15. alldodge

    Outside lower unit will not go up

    Being a 1979 do you have the 3 button up/down/trailer?
  16. alldodge

    Volvo Penta 3.0 Beeping and Ggoing Into Limp Mode

    The sensor is telling the ECM it's overheating. Don't see it being the sensor because it was replaced and same problem. That leaves the connections between sensor and ECM or it's the ECM
  17. alldodge

    Bone headed move - put the plug in with 3M 4200

    Supertech Marine (blue) and Mult-duty (red)
  18. alldodge

    Outside lower unit will not go up

    Most likely the trim limit switch is the issue. Can you get drive to come up using the trailer buttons?
  19. alldodge

    Rebuild old mechanical Fuel pump or go for Electric Fuel pump

    Many do change to electric and is simple enough to do. Let us know and we can supply the how-to
  20. alldodge

    Trim cylinder hose replacement

    With cylinders off, run pump dry Can try to clean tank out and refill or add more and run pump again to flush out
Top