Search results

  1. flyingscott

    Water Pump Kit P/N 394711 for 9.9 & 15 HP Johnson

    Depends on the year of the motor. On early 9.9/15 hp motors that went on the top of the drive shaft. Later models had 2 seals incorporated in the lower crankcase seal, So the o ring was no longer required. If it is required you will have a groove at the top of the shaft.
  2. flyingscott

    1993 Mercury 25hp 2-stroke outboard leaks gas out of vent hole on integrated carb?

    Fuel pump or Primer? If its the primer replace the diaphragm. If its the pump side make sure you used the correct gaskets.
  3. flyingscott

    need help identifying a 25hp motor

    96 or newer. Should be a silver disc by the throttle assembly, should have the serial #
  4. flyingscott

    Stator Wires sheared

    Typical 0f a 70s Merc. Best way to fix that is to replace it.
  5. flyingscott

    Ignition timing

    Why are you adjusting timing? What is your model #
  6. flyingscott

    1987 Johnson 15 HP J15RCUD Lost Spark

    Where is the ignition module on that? Disconnect the black kill wire from the module
  7. flyingscott

    Going rate on a good running 15hp?

    Electric start is a premium.
  8. flyingscott

    V4 trim on V6 engine

    Yes as long as the TNT units are the same. 93 was around the time they changed TNT units.
  9. flyingscott

    Best years for 70-75hp Johnson/Evinrude outboards

    Imported
  10. flyingscott

    1990 Evinrude 9.9/15 still starting rough

    Is the roller sleeve still on or is it missing?
  11. flyingscott

    2006 Johnson 15 HP 4 Stroke bogs when snapping throttle

    Also check your thermostat.
  12. flyingscott

    2006 Johnson 15 HP 4 Stroke bogs when snapping throttle

    Get a sonic cleaner. You run the risk of breaking something off in the orifice.
  13. flyingscott

    2006 Johnson 15 HP 4 Stroke bogs when snapping throttle

    Early 4 strks, especially early 2000s had the idles leaned out to pass emissions. The idle Jets were extremely prone to plugging and being difficult to clean. They also were leaned out to pass Emissions and that will also cause a bog.
  14. flyingscott

    1998 Evinrude 60HP 2 stroke Slow Max Speed

    Check Spark
  15. flyingscott

    Best years for 70-75hp Johnson/Evinrude outboards

    Stay away from the 75 Hp unless you have a light hull. The 70 hp is a much better all around motor. I also prefer the 86 and later as they are actually prop rated motors.
  16. flyingscott

    NLA Mercury outboard 25hp 2 stroke shift shaft retainer

    Pretty sure the water pump housing holds it in. Find somebody with a 3d printer.
  17. flyingscott

    '86 Evinrude 60 VRO E60TLCD with water in #3

    Pretty Common for the 49 cid blocks to leak from the exhaust Gaskets.
  18. flyingscott

    Spark plugs for a Merc outboard

    Champions are fine
  19. flyingscott

    modifying a crank rated 9.9 into its shaft rated counterpart?

    Later 9.9s came with the round tuner. Later 9.9s got everything the 15 did except the csrb.
  20. flyingscott

    E25RCNB Water pump leak after re-install

    I think your fine , but call Sierra if your worried
Top