Search results

  1. alldodge

    Cruise lines

    That is a nicer one then I had on my Ice Breaker. You had anti-roll out bars, we didn't, we had seat belts
  2. alldodge

    lifter issue and rock arm registration

    I think your fine. Once running for a few minutes oil will show up
  3. alldodge

    Cruise lines

    Looking at the 7 day in November out of New Orleans. Will be on the Escape Thanks for the link to the ships, looks like most all will have king. Maybe just go interior so we can stay closer to friends for fist trip
  4. alldodge

    Cruise lines

    Never been on one and think of them as petri dishes Looking into with friends going on Norwegian lines in November. There are several balcony places facing Aft but only so many facing Fwd. Looks like both have King beds and both talk about 2 beds which make a queen. Inside rooms have 2 twins...
  5. alldodge

    Kohler 5E Generator crank/no start K2/3 lit up

    My 4K kohler was a bear to start if it had sit for a good while. Installed a momentary ON switch to the fuel pump, this way I could run the FP before I tried to start. Buddy has a 5K gas kohler and it has a preheat switch and will not start unless the switch is held in. Yours not having one...
  6. alldodge

    No power to fuel pump and coil pack fuses on 2.5 efi outboard

    Need to scan the motor for codes Do have a manual showing 2.5/3.0 for 2002 and newer V6 Shows 2 places to look for +5V reference
  7. alldodge

    No power to fuel pump and coil pack fuses on 2.5 efi outboard

    Merc uses a main power relay (MPR) to power up the others. The MPR is energized by a ground being applied from the ECM. Not knowing which 2.5 you have the pic is an example. The MPR and fuel pump relays get power when key is turned ON. Unless the MPR sees a ground from the ECM nothing else gets...
  8. alldodge

    Kohler 5E Generator crank/no start K2/3 lit up

    Haven't go into the manual yet but does this one have a preheat switch?
  9. alldodge

    Should I start a work thread?

    Agree, There is a guy on the heavy equipment forum which started one called "This will be an interesting thread moving forward". He is a great mobile mechanic and also post things about how to and crud he gets into dealing with different businesses he does work for
  10. alldodge

    Volvo penta 5.0gxi 3869255

    Sorry I should have looked more then just the error. Still think it's the CKP but may also have an issue with the distributor cap. The flat cap is what most folks call "crap cap" because they can look great and fail Best to keep one in the boat because there is no warning when they fail
  11. alldodge

    Volvo penta 5.0gxi 3869255

    The CKP is down next to the crankshaft on the timing cover (item 7) part# 3858979 LINK
  12. alldodge

    Volvo penta 5.0gxi 3869255

    Finding code 81 is 5V reference low on the Crankshaft Position Sensor (CKP). Suggest measure the 5V reference with turn the key on and engine off See if it's actually 5V and not less than 5. Doing it this way will not set another code Disconnect the CKP and see if 5V reference comes back up.
  13. alldodge

    evinrude pl-88 load adaptor

    closed read the rules again Arty76
  14. alldodge

    2004 Larson 31 ft cabrio

    Fuse might be blown, bad switch or motor bad
  15. alldodge

    Merc 377 MAG DTS AXIUS electrical issue

    Bat switches off and the key is turned on. So all power is being feed through the keep alive power. There is voltage drop with that small wire Edit: not counting all the circuits being back feed
  16. alldodge

    How Do You Utilize Sliding Rear Window on Your Pickup

    ok guys Lets assume boards placed in without any padding and gap between it and windshield Next assume boards placed in with padding and no gap between padding and windshield
  17. alldodge

    2002 5,7 Mercruiser exhaust manifold keeps cracking - 5 times this summer

    Looks to me all the intakes are recessed further then the exhaust, and that could be normal due to valve lift. Intake lift is greater then exhaust
  18. alldodge

    2004 Larson 31 ft cabrio

    Might not have a macerator Look for a 1.5 to 2 inch hole on the side of the hull. The macerator will be connected nearby the hole. If boat has a generator there will also be a hole the same size for it
  19. alldodge

    daily music fix

  20. alldodge

    Lawrence FS 9

    Marketing scam, Oh you actually want to be able to use it, have to pay more
Top