Search results

  1. alldodge

    Volvo Penta 5.0 GXI-E - Won't roll over

    The flame arrestor is the same thing as the air filter/breather on a car. Its the aluminum color thing on top the motor It takes a but to bleed out all the air in the fuel rail before it goes smooth. If it starts doing it again will need to investigate
  2. alldodge

    2003 Crownline initial starting problem

    Welcome, need more info on motor model It's a GSI what? Pumping the throttle on a EFI/MPI does nothing. Some if the throttle is moved close to 3/4 then fuel is shut off, this is flood mode.
  3. alldodge

    Strange running

    Coming up as a 1987 carb TB ignition and mechanical fuel pump Do you know if it does it quicker if it has a full tank of gas as opposed to half tank? Can you dump the contents of the fuel filter in a clear container to see if there is anything but clean clear gas?
  4. alldodge

    5.0 GXI Gaskets

    IMO, auto is just fine
  5. alldodge

    Dean's List gets another motor

    Installed new module and it fired right up. Bilge needs to be repainted, cutlass bearing replaced, new drip-less seal, prop is back from shop. Hope in a week or so might have it back in the water. Picking up Grandson Friday so I'm not going to be doing much with the boat until we take him...
  6. alldodge

    Closed water cooling 5.0L Mercruiser

    ^^^Agree and add thru hull water pickup
  7. alldodge

    Volvo Penta 5.0 GXI-E - Won't roll over

    ok, I can see it, but it's so close really didn't know what it was That's the engine breather hose. It connects under the flame arrestor or right beside it. If the motor has any oil vapors they are drawn into the motor and burned
  8. alldodge

    Strange running

    It's a 5.7 what, serial numbers are best?
  9. alldodge

    Engine dies after running for several minutes

    I would leave it as-is, the boat has not been tested on the water. You did a tune up so it might be just fine
  10. alldodge

    Volvo Penta 5.0 GXI-E - Won't roll over

    Need to know where it goes just to have an idea. Is there a spot under the flame arrestor that it might fit?
  11. alldodge

    please help timing issue is the expected issue help!

    Just guessing but you may have blown the fuse in post 18 when you mentioned jumping the solenoid. Said it was running after jumping
  12. alldodge

    Mercruser 3.7 488 wiring help

    Moved to Merc section because while it is wiring, it's problem wiring the motor
  13. alldodge

    please help timing issue is the expected issue help!

    Yes and yes on the starter solenoid
  14. alldodge

    Mercruser 3.7 488 wiring help

    Motor side Helm side
  15. alldodge

    Engine dies after running for several minutes

    Should have around 14.5V at the Bat, might be an Alternator problem 11.3V at the coil is a bit high Does the coil get hot when running?
  16. alldodge

    2015 Motor MerCruiser 4.5L 250hp NO EC - OVERHEATING!

    With a kinked hose it stays cooler then when its not kinked Is the thermostat in stalled in crossover? Check the vanes on the circulating water pump. With hose removed use a long thin screwdrive and put up inside. See if it will make contact with the vanes and see if you can keep the pump...
  17. alldodge

    please help timing issue is the expected issue help!

    You need a voltmeter Might be the 90 amp fuse on the starter post. Inside it is a fuse
  18. alldodge

    I have a 1989 mercruser tops out at 3000 rpm

    Still might have been running a bit lean and burned a piston or a valve
  19. alldodge

    1990 1800SL owners manual

    Wiring under the dash should be what's in the aq151 manual If your talking about navigation lights, accessories and other then that's all generic and probably not going to find it
  20. alldodge

    I have a 1989 mercruser tops out at 3000 rpm

    Hows the compression?
Top