Search results

  1. R

    Johnson CD 24D drive shaft removal

    I understood how this was made / worked back in 1968.----There are no mystery parts on a CD model for me.
  2. R

    Johnson CD 24D drive shaft removal

    That pin drives the mechanical seal under the powerhead.----Very important.-----Need to look up there to see a slot for the pin to go through.
  3. R

    Evinrude 50 impeller

    Sometimes an adhesive is used to hold parts in position during assembly.-----Once assembled they serve no purpose.
  4. R

    1987 40hp evinrude vro (oil deleted) carb issue?

    The primer VALVE is not used to adjust mixture.---I think you need to revisit carburetor cleaning.-----Or consider the simple task of removing cylinder head to inspect in there.-----Compression values are LOW on your motor.
  5. R

    Johnson 150/175 carb saw

    Carburetor has nothing to do with starting.----Are you pushing in the key in while cranking it over ?-----The electric primer valve puts fuel directly into the intake air.----This fuel bypasses the metering circuits of the carburetors.
  6. R

    Johnson 150/175 carb saw

    Model # of this 150 ?-----Is it a GT 150 ?
  7. R

    Short shaft to long shaft

    Did the seller say that the 88 model is a short shaft ?-----Do you have a model # of the 88 shorty ?
  8. R

    Short shaft to long shaft

    I think the 88 model is a different block at 56 cubic inches.-----The 84 model is 49 cubic inches.
  9. R

    40hp Dead Top Cylinder

    Gasket around the nozzle ?
  10. R

    40hp Dead Top Cylinder

    It has been clearly stated that ---" spritzing fuel / oil mix into the top carburetor there is no change at all "----- This issue should be so easy to resolve !!
  11. R

    Evinrude 50 impeller

    Permatex Aviation can be for almost all applications.-----That motor really is not high tech and small leaks around water pump are not critical.
  12. R

    Evinrude 50 impeller

    There is no copper water tube on this motor.
  13. R

    Engine wont Start

    Remove sparkplugs.----Put 7 or 8 drops of fuel into each cylinder.----Install sparkplugs.----try and start it.-----Report exactly what happens.
  14. R

    Johnson 1986 40hp Power Trim & Tilt

    Try------evinrudeparts.ca----
  15. R

    Engine wont Start

    And what is ---" everything " ----That you have done ?-----Is the distributor turning ?----Belt timing correct ?
  16. R

    Johnson 20 hp. Carburetor problem

    That is the classic lean sneeze.------Idle mixture is too lean .----Or throttle plate is opening too soon.
  17. R

    '85 7.5hp, rebuilt water pump. Still issues with water flow to engine

    Good luck sorting this out.
  18. R

    brass propeller Johnson?

    It is a cupped prop.----Meant for an outboard and a boat that goes fast.
  19. R

    1980 E100 motor issues

    Timing on these motors does not go out of adjustment as a rule.------I will step aside on this.
  20. R

    Sea Ray 1977 200SR

    Round of applause for the above post !
Top