Search results

  1. R

    Murcury 850 thunderbolt stator

    Not sure where you are looking.----Just a few clicks and I find a stator with 2 yellow wires.---Ouch--$450 or so.
  2. R

    1973 9.5 Johnson

    If the coils are original they will be cracked.----All of this vintage Johnson / Evinrude have had coils replaced if they were regular runners.-----Only one way to find out and that means removing flywheel !
  3. R

    1972 Johnson 25 HP no spark

    The starter is assembled wrong in my opinion.
  4. R

    1972 Johnson 25 HP no spark

    Agreed those dock busters had 2 pinions to actually run the motor in reverse.-------There was no reverse gear on those to rob them of power.
  5. R

    Question on starting an outboard. And fuel line question(s)

    Turn the handle against the neutral interlock.-----Confused ??----Take the cowling off and see how this works !
  6. R

    10r77a rich lean adjust

    Going to be blunt here, as usual.-----You are looking in the wrong place talking to the wrong people.------Order a seal kit for a 1992 model 9.9 / 15 HP.----Parts such as the gearcase seals are the same year after year !!!----If in Canada order a seal kit at ---evinrudeparts.ca----Stuff is...
  7. R

    1973 9.5 Johnson

    Pop the flywheel off.-----Use the 3 threaded holes in the flywheel for a puller.----They are 1/4-20 NC thread.----Do not put screws in too far.-----Coils might be cracked.-----Install new water pump impeller before launching the boat.----Is the flywheel nut loose or is that the wrong nut...
  8. R

    Vintage Mercury Cooling Issue

    Likely just need to clean the breaker points.----That is if spark is the issue.-----These motors are so simple to trouble shoot.-----Motors sold privately usually have issues as well.
  9. R

    88' Force 85hp lower unit oil viscosity

    Is the oil level correct ?----Filled from bottom til oil came out the vent ?---Did you do any shimming to make sure you have correct tooth contact?----Or just installed the shaft and closed it up ??-----I don't think that oil is the issue here.
  10. R

    Need Model and year for 50's Evinrude

    7520 =1956-----and 7522 is 1957.-----The 15016 is a 1956 model 15 HP.
  11. R

    1989 Mercury 115 fuel/air issue

    Normal for the bulb to be soft after motor has run.----This fact confuses many people.-----Sparkplugs have nothing to do with testing the ignition.-----Does spark jump a gap of 3/8" on each lead , yes or no ?---Do you push the key in and hold it iin while cranking it over ?-----When motor fires...
  12. R

    Mercury 115hp

    Install a new factory impeller every 3 years on that inline 6 ,-----Cheap and simple.
  13. R

    Evinrude 40hk -90 reverse problem.

    Need to adjust the cable to match gearcase --In NEUTRAL ----with the rod set at 430 mm.
  14. R

    Help this rookie Read Timing

    These are all pretty well the same thing.----Why not make one as per earlier ( post 14 ) suggestion !
  15. R

    Evinrude 40hk -90 reverse problem.

    Is cable adjusted correctly ?----Remove cable at the motor.----Put motor in neutral.-----Adjust cable to fit the motor.
  16. R

    Evinrude 40hk -90 reverse problem.

    Put boat in the water and test run.-----I doubt clutch is worn to not be able to get reverse.----And what book were you using ??-----And are you sure this book had measurements for 89 and newer models ??-----The 88 and older motors were different !!
  17. R

    1956 6-volt 30hp Starter Help

    Did you take any ohm readings on the field and armature ?-----Have starter checked at a shop that has a tool called a ---" growler "
  18. R

    Evinrude 40hk -90 reverse problem.

    If it does not shift into reverse with that measurement and shift cable is moving correctly , you have an issue in the gearcase.
  19. R

    1972 Johnson 25 HP no spark

    I read him saying that his starter is turning clockwise about halfway down in post #10.-----Or maybe I am totally wrong again.
  20. R

    Evinrude 40hk -90 reverse problem.

    Did you measure the 430 MM with the gearcase in neutral , yes or no ?-----You need to be specific and answer questions----You are about 6000 km away and I cannot set this to 1 mm for you.
Top