Search results

  1. alldodge

    Prop choice Valvo penta 5.7 sx

    Don't know what motor you have but a 4500 lb boat needs at least a V8 and 35 should be no issue with that.
  2. alldodge

    What advice on renting a room out?

    That's the best I have a vacation rental near by that I rent thru vrbo and its been good. Could get more if I go ABB but don't like the way they do business. All good
  3. alldodge

    LED Driver question

    Probably easier to place a meter inline to measure current with the transistor and a pot. Adjust pot until get the proper current then replace with fixed Mostly because I don't know what diodes are used nor how they are wired
  4. alldodge

    LED Driver question

    OK so I use a LM317 and a 22 ohm resistor
  5. alldodge

    LED Driver question

    Well I guess that's my answer. Hmmm I was thinking of putting a 450 ohm resistor inline with just the hot side. Seeing what I'm missing guess that won't work 13.5/.0300 = 450 ohms Shows how much I don't know Thanks Oh and their are 30 LED's probably series/parallel Its an Ottlite
  6. alldodge

    Not firing

    The Gray wire changes to White at the fuel injector harness and then goes to the coil connector next to the Red wire
  7. alldodge

    Second Happiest Day . . .

    Go figure, manufactures like Formula sells a boat for 500K and starts using cheaper vinyl. Like you, my 94 Formula vinyl is still holding up but plan to have captains chair reupholstered do to wear but nothing is coming apart.
  8. alldodge

    Overheating

    Agree, they all look good
  9. alldodge

    MerCruiser 8.2 big block 2014 — shuts off after 5-7 min of running

    Does the charging system use an isolator or ACR? Start motor and measure voltage at the ALT and each Bat. Find the connection between ALT and non-charging Bat Otherwise remove cables and clean real good to shinny metal.
  10. alldodge

    1984 Mercruiser 305 with Thunderbolt ignition dies radomly.

    Agree with drill but take the distributor to the bench. Grind the stud flat even, then center punch it. Drill the screw out and if need be, go one size larger and retap. Can change the dizzy cap screws to one size larger if needed
  11. alldodge

    Rebuilt Mercruiser 140/3.0 doesn’t have enough power to plane

    In most cases there is shipping. With a long block gaskets will be the same. If any block is bored then its new pistons
  12. alldodge

    Rebuilt Mercruiser 140/3.0 doesn’t have enough power to plane

    Your motor could be rebuilt most likely, just need a good machine shop
  13. alldodge

    Rebuilt Mercruiser 140/3.0 doesn’t have enough power to plane

    Many here have had good luck with Michigan Motorz https://www.michiganmotorz.com/3-0l-marine-engine-1968-1989
  14. alldodge

    Loud, intermittent "knock" when at cruising speed

    Howdy Folks will have a hard time figuring out a knock without hearing it. You say its not from the motor, but being at 4200 rpm would have me thinking of preignition knock or a ping sound. Check you timing
  15. alldodge

    Bravo Shift Cable Adjjustment

    Yes, and the shift plate can be mounted anywhere. Some manufactures mount on the bulkhead if its easier for them
  16. alldodge

    No Start Condition - Volvo Penta 7.4 Gi

    What is the motor serial number? Check fuel pressure, it should be 36 to 41 psi Use a spark gap tester and see if your spark is constant and either white or blue
  17. alldodge

    Volvo Penta 5.0 osi engine cranks but won't start

    Could use a motor serial number, but start by measuring the fuel pressure at the rail. There is a cap covering the schrader valve and should get 50 to 60 psi when ignition is turned ON. No need for a noid light since it does start with starting fluid Do check the fuses closely. Could measure...
  18. alldodge

    Bravo Shift Cable Adjjustment

    Yes what BT said
  19. alldodge

    master bath remodel

    Agree no faucets on outside walls
  20. alldodge

    Quick Fuel 600 Carb, excessive accelerator pump arm lever play?

    Good deal Don't know of any using the quick fuel carb here at iboats, there are several using them on OSO
Top