Search results

  1. alldodge

    What was mounted here?

    That is where the dash pot is. A rod and spring design which is the choke for the carb. As the intake warmed up the spring would lift the rod and open the choke. Probably was replaced by an electric choke
  2. alldodge

    1994 seadoo gtx

    No expert but with it blowing the fuse, my guess is the ECM is the issue or coil, Could put a 20 amp fuse in and see if it will run. If it does then don't leave the fuse in. Something has just started drawing to much current. Use a ohm meter and check the coils to see if they are close to...
  3. alldodge

    TKS & diode & fuse

  4. alldodge

    Primary and Secondary Imbalance - Alfadan Outboard Motor ?

    Has some ice pics but 50% more hp and 50% less fuel :unsure: . Also listed as previous crowd sourced for over $1M. Now there wanting more Lots of long vids, no time to spend that much time right now https://www.alfadan.com/videos
  5. alldodge

    2 Black sparkplugs

    Could also be motor was not rebuilt correctly
  6. alldodge

    Carb or worse?

    Don't think I would be throwing in the towel just yet but do understand the frustration. Since the change in rocker adjustment is so sensitive you might need new lifter. If you go the donor route look for the serial number plate riveted on the block. It could be a 2.5L. The 3.0 will have...
  7. alldodge

    Yanmar 3YM30 temp gauge readings way off

    ok thanks The wiring should be of no issue so long as they have good connections. The gauges draw very little current and 18ga is enough and 14ga is even better. Assuming your gauges are the north American standard (240 ohm cold to 33 ohms hot) you can place the sender on the stove and heat...
  8. alldodge

    Mercruiser 5.7l Carb Audible Alarm Problem

    Ok a 98 with carb that's better If you turn the key ON and do not start for 5 minutes does it turn ON?
  9. alldodge

    Mercruiser 5.7l Carb Audible Alarm Problem

    Read the title but a 14 carb, that just makes me say wow So your issue is you want to hear the alarm when the key is turned ON? If you turn the key ON and don't start, the alarm stays OFF?
  10. alldodge

    Mercruiser 5.7l Carb Audible Alarm Problem

    What year is it? Carb, EFI, MPI
  11. alldodge

    Yanmar 3YM30 temp gauge readings way off

    Closed cool means it uses antifreeze and a heat exchanger. Open cool is no heat exchanger and its raw water cooled
  12. alldodge

    Yanmar 3YM30 temp gauge readings way off

    80C hope it was closed cool and not open Was the temp reading taken at the thermostat housing?
  13. alldodge

    Mercruiser 5.7l Carb Audible Alarm Problem

    Wat is your serial number?
  14. alldodge

    1975 351cu 233hp Mercruiser, riser block off plates or not?

    One side will run a bit hotter then the other which is correct. So far as the block off gasket, unless the motor is closed cool it should not use it
  15. alldodge

    2 Black sparkplugs

    What are the compression numbers? Your running regular gas and not high octane, right? What is the timing set at?
  16. alldodge

    Volvo Penta Trim Stopped Working

    Most likely the relay is the issue. Need to use a meter and see whats happening. Don't know which drive you have
  17. alldodge

    5.7l mercruiser gen 1 alpha 1 to vortec head swap problem please help...

    Agree, hence why we are discussing
  18. alldodge

    5.7l mercruiser gen 1 alpha 1 to vortec head swap problem please help...

    Said he's using premium gas
  19. alldodge

    Ipod Nano 5th Gen and Uconnect

    Only way to get my nano to play with Uconnect is with the Aux jack. Yes I know its old but still works, sort of just like me :ROFLMAO: . Uconnect also has apple play built in Tried to find drivers for Win 7 and that came up as a bust. Don't really want to upgrade to another Ipod because its...
  20. alldodge

    5.7l mercruiser gen 1 alpha 1 to vortec head swap problem please help...

    Depends on what your comfortable with. Even with a new carb I would check what the plugs look like after a few runs. Slow quickly and pull some plugs. Don't want to idle much because that can change the reading Either that or have to install exhaust bungs and use a air fuel ratio meter
Top