Search results

  1. Faztbullet

    Will evinrude work on johnson

    The 1996 is a 2 piece...just pop it out of clip and install the correct shaft .
  2. Faztbullet

    Idle mixture screws adjustments 135 hp 1990 Mercury

    Sounds like pressure valve on block is not bleeding off oil tank. This causes oil to be pushed thru oil pump and into fuel line making mixture extremly rich. Also seen it push oil seal out of pump flooding port side cylinder with oil
  3. Faztbullet

    Weird short on one cylinder

    Da ignition/kill switch is below that hole...
  4. Faztbullet

    Will evinrude work on johnson

    Just buy the correct driveshaft for the 1996...339059 and then it will fit
  5. Faztbullet

    Idle mixture screws adjustments 135 hp 1990 Mercury

    Did you check the thermal valve on starboard head? Does it do this after running and setting?
  6. Faztbullet

    Idle mixture screws adjustments 135 hp 1990 Mercury

    And may I ask why they need adjusting??? They are preset at factory that why the tamper proof caps.
  7. Faztbullet

    Timimg on mercury

    Check with a different tester as thats wayyy to low,,,should be 120+ with the small cc heads.
  8. Faztbullet

    Timimg on mercury

    That year is set at 22° at cranking speed
  9. Faztbullet

    Is my mercury oil injected?

    Serial places it late 1985 early 1986
  10. Faztbullet

    91 40hp 4cy 2-stroke Power loss

    The reeds or broke /cracked reed block will not cause symptoms shown in video.. it is a ignition problem.
  11. Faztbullet

    91 40hp 4cy 2-stroke Power loss

    Reed damage will not cause the symptoms shown.....
  12. Faztbullet

    1972 Merc 650E 3 CYL....fuel system Qs

    A timing light is your best friend right now......it will show you ignition drop outs at all rpms
  13. Faztbullet

    Best Outboard Today

    Yer best picks for 90hp to 600hp outboards are: (1) Merc (2) Yammy (3) Zuki
  14. Faztbullet

    Metal shavings in reed block

    Detonation that broke rings..common with bad idle/advance module. Yes it can be bored, .020 should clean it up easily
  15. Faztbullet

    91 40hp 4cy 2-stroke Power loss

    Check each cylinder with a timing light..
  16. Faztbullet

    1986 90hp Merc pwr of twr lower unit disassembly

    Here is your gearcase...number 49
  17. Faztbullet

    1986 90hp Merc pwr of twr lower unit disassembly

    If they were round ball bearing about 3/16 dia these are prop shaft pin bearings.
  18. Faztbullet

    What brand of 2 stroke oil do you use for your Johnson Evinrude 2 stroke

    Penzoil and Super Tech...and never had a problem
  19. Faztbullet

    New Carb

    What makes you think its a carb problem???? Could be ignition
Top