Search results

  1. alldodge

    Bravo 1 gimbal to transom seal

    Use a new seal and attach seal to housing with bellows adhesive
  2. alldodge

    Replace or Repair, where to start?

    Using AF then your motor is closed cool? I'm not understanding that you wouldn't just remove the radiator cap I'm thinking its not closed cool and the impeller went bad so the pump wasn't pumping any water. If this is the case then pouring AF down the thermostat just ran back out Being a...
  3. alldodge

    Marina's

    Agree, and also find FB page on the body of water where you boat. The locals will tell you the low down about the different marina's
  4. alldodge

    Best Browser add on's

    Have not heard of Greesemonkey, might look into that one I find a PW manager is so much easier and also keeps me from reusing the same parts of a PW in different places. While FF keeps my list synced up on all computers I use, I do wonder how secure it is, they say it is
  5. alldodge

    Blowing ignition fuse

    It started when the fuel gauge was replaced. All I can do is guess, but my thought is one of the purple wires got to close to a ground, or there was a misswire when gauge was installed. Mentioned, you disconnected all the gauges, so in doing something was moved. The problem might show its...
  6. alldodge

    Wheelchair Accessible Resto-mod

    Not more then 3 and 2 would be better. At 3 its 3 psi per square inch, so 20 sq ft of surface = 2880 sq in (20x144) x 3 psi = 8640 and 2 psi = 5760
  7. alldodge

    Blowing ignition fuse

    While anything is possible, in most cases its hardly ever the coil. To find out if it is, remove the small wires off the + side post and see if it ok then
  8. alldodge

    Mercruiser coil 2006 MCM 5.0 MPI

    Don't think there is one My question is why? Spark burns fuel, if there is more spark its still going to burn the fuel and if it burns to fast it could cause preignition
  9. alldodge

    Anchor windlass

    In your case I would let the windless feed all the rode in. Take the bitter end of the rode and either attach something inside the anchor locker, or attach something to the end which will keep it from exiting
  10. alldodge

    Mercruiser spark plug replacement question?

    Don't re-gap iridium plugs, this can break/crack the iridium coating 20 year champion plugs looked real nice when replaced, and new plugs didn't change any performance I could determine
  11. alldodge

    Super Bowl LV

    Old Brady vs young Mahomes Old guy seems to be winning
  12. alldodge

    Blowing ignition fuse

    Something is going to ground. Purple wire is 12V and Black is ground The Red/purple feeds the key switch from the 50 amp fuse on the motor thru the fuse Get a volt ohm meter (multimeter) and disconnect the battery. Connect the negative lead to ground (black) and the positive (red) to purple...
  13. alldodge

    3.0 Alternator Alignment

    Don't know which ALT you have but many use press on pulleys, but some have a nut which hold. If there pressed on, most can be repositioned In any case I did understand about wanting to move the crank pulley
  14. alldodge

    TVM Fault Critical - Twin 377's B3 with DTS and AXIUS

    With the Bats testing good, then there is an alternator problem. Once motor goes up to 1200 rpm the first time you should see around 14.5 volts. The most I saw was 13 something Put a voltmeter on the battery's and if your seeing the same voltage then its in the charging circuit
  15. alldodge

    Motor won't turnover, making weird sound

    The starter is not engaging. Needs to be removed and inspected/cleaned/ and/or replaced
  16. alldodge

    3.0 Alternator Alignment

    O don't see an issue with adding a shim so long as the bolts go in far enough to hold. Can the pulley on the ALT be moved in/out to align?
  17. alldodge

    Super Bowl LV

    Super bowl again, another day with nothing on TV but old reruns My sister lives in KC MO and she's going nuts. I don't care who wins, only watch FB when there is nothing else. Hope the commercials will be good
  18. alldodge

    New comer like to buy a boat!

    Howdy Your saying you want a wood hull boat like the old Chris Craft?
  19. alldodge

    Wheelchair Accessible Resto-mod

    There is a max bend radius on most cables, have check manufactures spec The marinas near by have toons which are U shaped. They are heavier built for rental use
Top