Search results

  1. alldodge

    voltage help

    When your turn the key ON do you have 12V on the positive side of the coil? Disconnect the gray wire on negative side of the coil going to the tachometer if you have one
  2. alldodge

    5.7L Gi-A will no longer start

    Run through this troubleshooting
  3. alldodge

    Farm Tractor

    I'm looking for a farm tractor and will probably get a kubota, but will look at others. Thinking of a 60 sum tractor and doesn't need a loader but it would be a plus. Was going to buy new with cab and at least 70HP, but the cab part came from the wife. Been using a friends open ROPS for the...
  4. alldodge

    Drain plug issue 2.5l mercruiser

    Appears to me you have a apples and oranges thing. If that is the block drain hole then it should be 1/4NPT (National Pipe Threads). The fitting your trying to install is not pipe thread and is half of the fitting The original fitting was installed using an extension 22-64425 Then the...
  5. alldodge

    Stability?

    Grady's are also heavier then some of the same size boats. Has similar hull as our Formula's
  6. alldodge

    Changing Distributor Cap and Rotor, throw timing off?

    The distributor cap for your motor gives folks trouble quite often. Not saying it is the issue but many carry a spare because they can look great but have issues. Many call it a crap cap :D To remove, remove screw holding cap and lift up. Rotor is removed the same way by removing 2 screws...
  7. alldodge

    Hook up remote starter switch?

    Connect remote start on the large starter post and the other on the Yellow/Red on the smaller post. Turn key to ON then go to the motor and start it ​​​​​​​
  8. alldodge

    2005 350 mag (5.7) smartcraft faults Water pressure + fuel level sender

    That isn't going to work, your feeding a analog signal (variable voltage) to a digital gauge. That wire comes from the standard oil pressure sender You need a digital signal 8M6000626 for that gauge which goes thru the ECM Do you have the 3 pron plug to connect it up?
  9. alldodge

    Mercruiser 188 backfiring through the carb ONLY going forward

    You have something that is clogged up. The Ford open cooling routing is kind of weird IMO but does work. Look at the gasket between elbow and manifold
  10. alldodge

    5.7L Gi-A will no longer start

    Code 44 is unable to detect knock, and while might happen with it disconnected, it normally happens because the ECM tries to make it knock during throttle up, and does not get one. Right now don't think that's your issue Which coil was replaced item 12 or 22?
  11. alldodge

    1994 Four Winns Horizon 215 5.8L EFI OMC

    The throttle plate is connected to the throttle position sensor (TBI) and tells the ECM its position to adjust fuel Yes, just stick the hose going to the filter into the can and run off it Thrim trim system is part of the transom assembly
  12. alldodge

    4.3 vortec 2008 aprox. Alpha one 1985 s/n A802400 Overheating

    Could you you clarify what you have so I can understand the possible variables? What year Alpha drive? The thermostat housing is a 1985 type, but what year are the exhaust manifolds? Do the hoses route like this
  13. alldodge

    Y pipe compatability

    Would yours happen to look like this? Its from manual 2
  14. alldodge

    MV-2 Control on 1996 Regal Rush xp120 jet boat

    Looks like this after posting
  15. alldodge

    What Inline Fuse For 5.7 Mercruiser Starter?

    Here is the 90 amp https://www.iboats.com/shop/blue-sea...-terminal.html Looks like this on the starter
  16. alldodge

    Deep Sixing Single Point Drain.

    Your exhaust manifolds and elbows are different, they are dry joint where Maclin's are wet. The wet manifolds may not be able to pass the same amount of water, or Merc wants to keep the manifolds warmer then the wet type. Don't know just trying to understand the changes. The V6 will put out...
  17. alldodge

    Interesting question about over revving.

    Yes they do
  18. alldodge

    Boat buy true story

    Buying boat without test ride Guy I know sells his small cruiser and buys the new boat below without a test drive. Boat is put on muffs and it fires up, all looks good. Takes it took the water and has a fun day but notice the bilge pump keeps turning on. Once back home at a shop they tell...
  19. alldodge

    Deep Sixing Single Point Drain.

    Need to find out what your serial number is. If it is between 0M300000 THRU 0M614999 then the below will work. If its not then need some more thought. If yours is different and has a bravo drive some other routing can be needed. The hose coming from cool fuel to the single drain needs to be...
  20. alldodge

    Engine doesn't start without throttle opening

    Yes your right, I forget that VP can be 50-60 psi Don't think its a leaking injector because of MPI and would not be all of them. The flood mode with the throttle may just cause what is not working to start working. Right now its unknown, and as with these motors they need to be scanned for...
View older results
Top