Search results

  1. alldodge

    2006 Tahoe 190 4.3 engine

    While TKS carbs do have their issues, this statement tells me the mechanic is in name only, and really does not understand the issue. You can take a standard 2 barrel carb with electric choke and it will work fine (note the fine, it will only work fine provided it is setup correctly and there...
  2. alldodge

    3 battery isolator

    The DVSR or ACR (same thing for the most part) are one to one. To use this setup you would use 2 of them. That said, if a bat was drained to some extent the ALT would not be able to totally recharge the bat using your current setup. If the motor run long enough then the recharge would...
  3. alldodge

    Trim will go down, but not up

    +1 agree, probably the trim limit. To test find the blue/white and purple/white wires and connect them together
  4. alldodge

    5.0 to 5.7 mpi swap same ECM

    It uses the same Delphi part number but not program
  5. alldodge

    2006 Four Winns Funship 224 Volvo Penta 5.0 GXI Takes Long to Get Full Power & RPM

    Never did say which Gxi you have but the guy might be right and I may have misunderstood Fun Times , wouldn't be the first time :facepalm: but found this, so it depends if yours is a B/C/D or E
  6. alldodge

    3 battery isolator

    The changer is for shore power, IF it is installed. Not knowing what you have but most have the typical 1, 2 ALL and OFF switch. So yours would be more like this other one. I would suggest using automatic charge relays (ACR) over an isolator, less issues. I just removed my 3 bank isolator...
  7. alldodge

    3 battery isolator

    Not the best method, but all it will take is installing a 3 bank isolator and add the new lead to the 3rd bat. Should install another switch
  8. alldodge

    350 mag stops running

    If you could get a fuel pressure gauge (local auto store loaner tool) and adapter (see below) to attach the gauge and see what pressure does No 91-806901
  9. alldodge

    Torque specs for impellar housing?

    That's a bummer but first column is lb-in (pound inch or called inch pounds), the second column is foot pounds
  10. alldodge

    OMC cobra 4.3 batwing exhaust manifold problems!

    It should sit closed when the motor is not running, if that's what you mean. Also if you have this style of manifolds they should be replaced.
  11. alldodge

    Cold starting problem

    No, the key (letter A) turns on the slave relay (letter C), and the slave relay turns on the starter solenoid (letter E)
  12. alldodge

    Cold starting problem

    OK, I would go to the slave relay first. There are 2 large post on top and 2 small on the bottom. Jump across the 2 top ones and the starter should engage. When key is turned to start this is energized and then power goes to starter solenoid 89-96054T
  13. alldodge

    1996 mercruiser 5.7 efi tbi stalling at idle

    This is the classic IAC issue, will run above 1000 and will dies below it. The idle plate is set for a specific air gap and then the IAC takes care of the rest. Need to check for a vacuum leak, then test the IAC connections.
  14. alldodge

    Lower shift cable core won't go in

    Her is how it should be routed
  15. alldodge

    5.0 Mercruiser loses power gradually?

    Have you changed out the fuel filter? You should have TBI and will need an adapter to connect inline. Remove the fuel line at the TB and install it. 91-806901
  16. alldodge

    Fuse for main power wire

    The wiring I'm finding for the OMC shows a 50 fuse, headed to the helm. Once there their is normally a 20 amp fuse which feeds the ignition. This is for a V8 but the basics should be the same
  17. alldodge

    2006 Four Winns Funship 224 Volvo Penta 5.0 GXI Takes Long to Get Full Power & RPM

    That is for a car, it will not work for your motor. You need connector 24024 to scan your motor
  18. alldodge

    Mercruiser 7.4l engine rotation

    Look at the props, if the prop rotates CCW going forward the motor is LH, if it rotates CW then its RH. Standard is LH
  19. alldodge

    Is this the wiring for my alarm?

    That is a connector which would go to a switch to turn sound the alarm. The alarm is in a pic below and note the two individual wires. The harness is made for different models and it could be used an inboard transmission temp switch. If I remember correctly you have smartcraft which is...
  20. alldodge

    '84 3.0 wiring

    Don't know of any ALT which uses just two wires other then a one wire ALT that also has a ground wire. Being an 84 your motor is listed as the 140 and wiring is below. Note BIA is the standard boating industry wire colors which started in the 80's
Top