Search results

  1. alldodge

    Solved: Regal 2450 / Volvo Penta 5.7 GXi - Ignition Switch Issues

    This doesn't look right
  2. alldodge

    4.3 GXi stumbles, no power, won't take off

    Will need an adapter like Merc's 91-806901 and place it inline
  3. alldodge

    Mercruiser 7.4 Electrical Problem

    There is a 90 amp fuse on the starter which looks like this. Blue sea and others make them
  4. alldodge

    Which Outdrive

    OK does look like the boat did not use jackshafts. The motors were disconnected so the drives and transom assemblies could be stripped from the boat Suggest get in there with a screw driver and try to push it into the transom and stringers. Try to find out if the bat hull is solid. My...
  5. alldodge

    Which Outdrive

    And next set
  6. alldodge

    Which Outdrive

    Lets see what we have
  7. alldodge

    2005 Optimax 75hp help please

    Have not found your motor but found a 2000 to 2001 optimax and here is the pressure reads listed and a link to the pages. http://boatinfo.no/lib/mercury/manuals/115-135-150-175_optimax.html#/648
  8. alldodge

    1989 3.0 ENGINE RUNNING PROBLEM

    Using the pertronix ignition you don't need an external resistor coil, need one with internal resistor. The purple wire feeding the distributor should be a resistor wire, can verify with an ohm meter. The Purple/Yellow comes from the starter and supplies full 12V during starting. Don't know...
  9. alldodge

    Looking for a quick and easy way to stow dock lines after shoving off

    As an old Coasty I coil and toss or hang the lines under a hatch. Using this method they never tangle and are ready and stay separated until next use
  10. alldodge

    Funny thread found on other forum

    I like twins :D
  11. alldodge

    leaf springs have no shackels

    Manufactured wanted to, cheaper to use then others
  12. alldodge

    interrupt switch with new engine

    Reposting the pic so others may see it better next time
  13. alldodge

    4.3 v6 mercruiser late 80's engine problems at full throttle.

    The stone is the pump filter part number 35-8M0046752. From the look of the pump and filter I'm thinking your gas may be OK http://www.mercruiserparts.com/bam/s...y/31472/919/80
  14. alldodge

    Mercruiser 5.7/Bravo 1 - Clanking Sound from Rear of Engine

    No, the drive shaft is Rockwell hardened and the coupler is not. The coupler is the sacrificial item which is used to protect the drive and the motor. Look inside at the coupler splines and the pattern should match the drive shaft. If the squared off slots look a little like pointed...
  15. alldodge

    1999 Mercruiser 3.0L Starter switch wiring question

    Purple is 12V when key is turned to ON (I terminal) Yellow/Red is the start circuit (S terminal) Red/Purple comes direct from the Battery via the breaker This is the start wiring, and note the yel/red goes thru the neutral safety switch This is the power ON circuit. This pic displays how to...
  16. alldodge

    Temp gauge

    No, that is the fuel pump leak hose. If the fuel pump leaks the hose will fill with gas and move it to the carb The temp sender should be in the thermostat area by the blue arrow
  17. alldodge

    engine hard to start when hot

    This is the wiring for the IAC on a Merc motor and so far as I understand, same parts are used by VP
  18. alldodge

    2013 Tahoe Q5i Steering tightness/locking up

    Not a cable as in like a close line and pulleys, there is a spiral cable inside the steering cable.
  19. alldodge

    Indmar 5.7 TBI transplant into 88 SeaRay - Shift Interrupt & Base Ignition Timing

    Sorry, been gone for a bit. Being you have a MEFI-1 ECM you don't want to do what I mentioned in a previous post. The schematic shows the Merc 5.7 wiring which is close to what you have but may not be exact. Look for the Merc style DLC connector If you have this connector then a pin between...
  20. alldodge

    Bennett Trim Repair And Auto Pro Install

    Also seeing two different pics of the item, are they both correct?
Top