Search results

  1. R

    1996 venom 200 double problems tachometer/reverse

    Verify the shift rod height.--Post the value you see as removed.------Remove shifter cable ( boat in the water) and see if you get reverse.----Cables do wear out internally.
  2. R

    70’s Mercury 850 Thunderbolt - Distributor Wires

    Rotor may be part of the shaft , and it does not come off.
  3. R

    HELP!! Carb. / choke /timing settings 1986 50 HP Evinrude --->

    The red lever is for manually opening the primer valve.----Used when you have a dead battery and need to start this motor with a rope.-----The trouble shooting on any " trouble " motor starts with a compression test.----Post the actual values here.
  4. R

    1987 Mercury 45hp classic 50 control cable anchor

    Folks struggle with that simple latch.----They end up breaking it.-----I would use hose clamp / tie wraps to hold cables in place .----Then look for the proper part at my leisure.
  5. R

    I'm stumped, please help. 1996 40HP force outboard

    Does spark jump a gap of 3/8" on both leads , yes or no ?
  6. R

    Goo

    Remove the sensor coil and inspect it.---Post the ohm value.----Remove the charge coil and inspect it.----Post the ohm value.-----No need to replace the CDI based on wild guesses.
  7. R

    I Got Me a Mercury !!!

    These little Merc's need a new impeller every 3 years.
  8. R

    Honda BF25D Low power under load at open throttle

    A compression test is step #1 on any motor.----Next is a spark check.-----Motor could be running on 2 of 3 cylinders.----And yes , it will rev up on 2 of 3 cylinders on a hose.----Perhaps motor was sold for a reason.
  9. R

    115 optimax bad middle cylinder

    It is a " high tech " parts motor.-----Not worth fixing this new junk.
  10. R

    Bouncing Tilt and Trim on Way Down

    Clean the corrosion between plastic bushings and aluminum housings.
  11. R

    79 Chrysler 115 Won't go into gear

    Inspect gearcase oil .----Any water in oil ?---Remove lower unit.----Inspect spline at the top of the driveshaft.
  12. R

    Evinrude 9.9 HP Model # 10924B

    How did this motor run for you last season ?----Do some simple testing / inspection and post answers.------Inspect fuel pipe INSIDE the tank.----Post actual compression values.-----Does spark jump a gap of 3/8" on both leads?-----Is there a pulse from the PRESSURE port where fuel pump mounts ...
  13. R

    Partial transom repair

    Cut the outside skin of fiberglass off it.----Dig out the rotten plywood.-----Dry everything.----Glue in 2 layers of plywood as needed.----Glue the outside skin back on.-------If you have some power tools this is a 2 day job.----Or a week of 4 hour afternoons.
  14. R

    81 omc sterndrive

    Selecting reverse to go forward is NOT a good idea.
  15. R

    High-Speed Jet NLA??

    If in Canada----evinrudeparts.ca----might be able to help you.
  16. R

    1996 Johnson 60hp 2 stroke not getting to full speed at random times

    Running on 2 of 3 cylinders explains it.----Need to install a new water pump impeller.----Or at least test your overheat horn.
  17. R

    Stripped threads on carburetor

    Replace the carburetor body.----Gasoline leaking on a boat is an issue.-----Or add a parachute to the safety inventory on the boat.
  18. R

    1996 Johnson 60hp 2 stroke not getting to full speed at random times

    Nobody can see , touch or hear tour motor.-----Provide accurate information.-----Does spark jump a gap of 3/8" on each lead?----Test this at more than 1 throttle position , as there could be a broken wire.----Water pump impeller replaced every 5 years?-----Post actual results of a compression...
  19. R

    I used up all my curse words yesterday

    All part of people good with computer aided design.----They are good with a computer , but are not experienced automotive mechanics.-----The job is to make / design parts that are assembled by ROBOTS at a parts supplier.-----Then assembled / snapped together at an assembly line.----There is no...
  20. R

    How much slip does your prop have ?

    Similar to the ----" what oil is best " ----Threads.------There is no easy answer.
Top