Search results

  1. flyingscott

    1996 15 HP mercury with spark on only one plug

    Good luck with your motor.
  2. flyingscott

    1996 15 HP mercury with spark on only one plug

    Put up a pic of this ignition. I dont remember low and High speed coils on those motors.
  3. flyingscott

    1996 15 HP mercury with spark on only one plug

    Put up.a pic of this magic flywheel with no magnets.
  4. flyingscott

    Suzuki Dt16 Starter

    Put up a pic of the starter
  5. flyingscott

    1996 15 HP mercury with spark on only one plug

    Are you sure the magnet is not missing?
  6. flyingscott

    1996 15 HP mercury with spark on only one plug

    Are you positive there are not 2 magnets?
  7. flyingscott

    1996 15 HP mercury with spark on only one plug

    Well if the spark moves with the trigger wires what does that tell you?
  8. flyingscott

    1996 15 HP mercury with spark on only one plug

    Does that have the digital ignition without the manual advance?
  9. flyingscott

    1996 15 HP mercury with spark on only one plug

    CDI have the test procedures for your ignition.
  10. flyingscott

    Excessive smoking

    Checked the fuel Pump?
  11. flyingscott

    Excessive smoking

    Float set right? low speed set correctly?
  12. flyingscott

    70 hp Tohatsu pops out of gear

    If it doesn't bang when doing that, I would suspect the hub.
  13. flyingscott

    Carb for 1985 Mercury 25XD

    Do you know anybody in WI? Pretty sure I have one. You are also missing the whole choke assembly.
  14. flyingscott

    Just can not figure it out

    Never saw a 2+2 75. Give us a pic of this unicorn.
  15. flyingscott

    87 Johnson 30

    Don't think those ever came with one. Look to the aftermarket as panther and CMC both make small units. As far as a tach that should be easy. Either find a timing light with the 2 strk function. Or buy a cheap tach off of ebay
  16. flyingscott

    2001 mercury 125 2+2

    I would be looking at your fuel Pump
  17. flyingscott

    Just can not figure it out

    Put up your starting procedure. Are you pumping the ball till hard? Raising the lever to get a high idle? Using the choke? Of you are going to use starting fluid at least use the stuff with lube in it.
  18. flyingscott

    1976 Johnson outboard 9.9HP 10R76H diagnosis

    Check the points and condensers. Also check the kill switch
  19. flyingscott

    New to us Boat!

    Change your water pump and make sure your lower unit is In good condition.
Top